Abstract:Abstract Multi-segmental lumbar degenerative disease, including intersegmental disc degeneration, is found in clinical practice. Controversy still exists regarding the treatment for cross-segment degeneration. Oblique Lateral Interbody Fusion (OLIF) with several internal fixations was used to treat cross-segment lumbar degenerative disease. A whole lumbar spine model was extracted from CT images of the whole lumbar spine of patients with lumbar degeneration. The L2-3 and L4-5 intervertebral spaces were fused with OLIF using modeling software, the Pedicle screws were performed on L2-3 and L4-5, and different internal fixations were performed on L3-4 in Finite Element (FE) software. Among the six 10 Nm moments of different directions, the L3-4 no surgery (NS) group had the relatively largest Range of Motion (ROM) in the whole lumbar spine, while the L2-5 Long segmental fixation (LSF)group had the smallest ROM and the other groups had similar ROM. The ROM in the L1-2 and L5-S1 was relatively close in the six group models, and the articular cartilage stress and disc stress on the L1-2 and L5-S1 were relatively close. In contrast, the L3-4 ROM differed relatively greatly, with the LSF ROM the smallest and the NS ROM the largest, and the L3-4 Coflex (Coflex) group more active than the L3-4 Bacfuse (Bacfuse) group and the L3-4 translaminar facet screw fixation (TFSF) group. The stress on the articular cartilage and disc at L3-4 was relatively greater in the NS disc and articular cartilage, and greater in the Coflex group than in the Bacfuse and TFSF groups, with the greatest stress on the internal fixation in the TFSF group, followed by the Coflex group, and relatively similar stress in the Bacfuse, LSF, and NS groups. In the TFSF group, the stress on the internal fixation was greater than the yield strength among different directional moments of 10 Nm, which means it is unsuitable to be an internal fixation. The LSF group had the greatest overall ROM, which may lead to postoperative low back discomfort. The NS group has the greatest overall ROM, but its increased stress on the L3-4 disc and articular cartilage may lead to accelerated degeneration of the L3-4 disc and articular cartilage. The Coflex and Bacfuse groups had a reduced L3-4 ROM but a greater stress on disc compared to the LSF group, which may lead to disc degeneration in the long term. However, their stress on the articular cartilage was relatively low. Coflex and Bacfuse can still be considered better surgical options.

Finite Element Analysis of the Influence of Different Posterior Fixations of Two-level Anterior Lumbar Interbody Fusion on Adjacent Segmental Degeneration

Topping-off surgery vs posterior lumbar interbody fusion for degenerative lumbar disease: a finite element analysis

Comparison of posterior versus transforaminal lumbar interbody fusion using finite element analysis. Influence on adjacent segmental degeneration

Biomechanical Study of Proximal Adjacent Segment Degeneration after Posterior Lumbar Interbody Fusion and Fixation: a Finite Element Analysis

Comparison of Posterior Versus Transforaminal Lumbar Interbody Fusion Using Finite Element Analysis

Preserving Posterior Complex Can Prevent Adjacent Segment Disease Following Posterior Lumbar Interbody Fusion Surgeries: A Finite Element Analysis

Does Tlif Aggravate Adjacent Segmental Degeneration More Adversely Than Alif? A Finite Element Study

A three-dimensional finite element analysis of effect of lumbar posterolateral fusion with pedicle screw on adjacent intervertebral discs

Finite Element Modeling for Biomechanical Comparisons of Multilevel Transforaminal, Posterior, and Lateral Lumbar Approaches to Interbody Fusion Augmented with Posterior Instrumentation

Biomechanical Comparison of Supplemental Posterior Fixations for Two-Level Anterior Lumbar Interbody Fusion

Oblique lateral interbody fusion with internal fixations in the treatment for cross-segment degenerative lumbar spine disease (L2-3 and L4-5) finite element analysis

Does anterior lumbar interbody fusion promote adjacent degeneration in degenerative disc disease? A finite element study

Biomechanical Evaluation of Anterior Lumbar Interbody Fusion with Various Fixation Options: Finite Element Analysis of Static and Vibration Conditions.

Does Disc Space Height of Fused Segment Affect Adjacent Degeneration in Alif? A Finite Element Study

Biomechanical properties analysis of posterior lumbar interbody fusion with transpedicular oblique screw fixation

Biomechanical Analysis of Adjacent Segments after Spinal Fusion Surgery Using a Geometrically Parametric Patient-Specific Finite Element Model

Does Osteoporosis Affect the Adjacent Segments Following Anterior Lumbar Interbody Fusion? A Finite Element Study

THE FINITE ELEMENT ANALYSIS OF LUMBAR FUSIONS

Establishment of 3D-finite element model for analysis of biomechanical stability of extraforaminal or transforaminal lumbar interbody fusion

Evaluation of S2 Alar and Traditional S1 Pedicle Fixation for Severe Lumbar Spondylolisthesis in Different Bone Mineral Densities: a Finite Element Analysis

Biomechanical evaluation of strategies for adjacent segment disease after lateral lumbar interbody fusion: is the extension of pedicle screws necessary?