Effects of remineralization procedures on the surface physical properties of enamel after HP bleaching

Sen-sen XIE,Ji-yao LI
DOI: https://doi.org/10.3969/j.issn.1003-6350.2014.09.0487
2014-01-01
Abstract:Objective To discuss effects of remineralization procedures on the surface physical properties of enamel after HP bleaching. Methods All the bovine blocks were distributed randomly among four groups:group A:artificial saliva;group B:0.09%sodium fluoride solution;group C:tooth mousse;group D:tooth mousse plus 0.09%sodium fluoride. Color (L, a, b values) and hardness (KHN) were measured at before and after bleach, and 1 week and 2 weeks after remineralization. The results were analyzed by single factor analysis of variance, and appearance of ada-mantine layer was observed by electron microscope after remineralization process. Results The surface microhard-ness value got smaller after bleaching in each group. There was no significant difference in group A during remineral-ization process, while significant difference was observed one week after remineralization in group D (P<0.05) and two weeks after remineralization in group B and group C (P<0.05). There was no pittings in group D and less pittings, erosions in group B, C.ΔE increased 7.22~7.85 units after bleaching, decreased 1.35~1.69 units one week after remin-eralization and remained the same in the rest time, there was significant difference one week after remineralization in groups A, B, D except group C. Conclusion Using tooth mousse with or without sodium fluoride could decrease the relapse of tooth color, thus increase the aesthetic effect.
What problem does this paper attempt to address?