Influence factors of different doses of Alloxan on diabetic mice model

朱金羽,向星炜,张景昊,姜正二
DOI: https://doi.org/10.3969/j.issn.1004-0412.2019.03.002
2019-01-01
Abstract:Objective To investigate the influence factors on diabetic mice induced by different doses of Alloxan and different routes of administration. Method 110 male Kunming mice, with a weight of 18~26 g, were divided into 5 experimental groups, of which 50 mice in intravenous injection group were divided into two groups of small and large doses (60 mg/kg·bw, 80 mg/kg·bw), and another 50 mice in the abdominal injection group were divided into two groups of small, large dose (200 mg/kg·bw, 250 mg/kg·bw), and 10 mice in the control group. At third and seventh days after injection, the changes in the weight and blood sugar of mice with different doses and different doses of Alloxan were compared, and the success rate and death rate of the model were compared. Results The success rate of modeling in the intravenous route was lower and the mortality rate was higher than that of intraperitoneal injection. The success rate and death rate of the model third days after injection were all lower than seventh days. There was no significant difference between the small and large dose groups in each group of intravenous and intraperitoneal injection (P>0. 05). The increase of blood sugar showed a significant dose dependence;and the effect of body weight change on the model was not significant. The small dose (200 mg/kg·bw) in the intraperitoneal injection, compared with the large dose injection and the intravenous injection group, had a high success rate and a lower mortality rate. Compared with the control group, the difference was significant (P<0. 05), and the difference between the two groups was also significant (P<0. 05). Conclusion Intraperitoneal injection of Alloxan at low dose (200 mg/kg·bw) resulted in high molding rate, low mortality, small fluctuation in blood glucose and stable modeling.
What problem does this paper attempt to address?