Abstract:Abstract Damping of thermoacoustically induced pressure pulsations in combustion chambers is a major focus of gas turbine operation. Conventional Helmholtz resonators are an excellent means to attenuate thermoacoustic instabilities in gas turbines. Usually, however, the damping optimum is in a narrow frequency band at one operating condition. The work presented here deals with a modification of the basic Helmholtz resonator design overcoming this drawback. It consists of a damper body housing multiple volumes that are connected to each other. Adequate adjustment of the governing parameters results in a broadband damping characteristic for low frequencies. In this way, changes in operating conditions and engine-to-engine variations involving shifts in the combustion pulsation frequency can conveniently be addressed. Genetic algorithms and optimization strategies are used to derive these parameters in a multidimensional parameter space. The novel damper concept is described in more detail and compared with cold-flow experiments. In order to validate the performance under realistic conditions, the new broadband dampers were implemented in a full-scale test engine. Pulsation amplitudes could be reduced by more than 80%. In addition, it is shown that, due to sophisticated damper placement in the engine, two unstable modes can be addressed simultaneously. Application of the damper concept allowed a considerable increase of the engine operating range, thereby reducing NOx emissions by 55%. Predictions obtained with the physics-based model excellently agree with experimental results for all tested damper geometries, bias flows, excitation amplitudes, and most importantly with the measurements in the engine.

Development of Gas Pulsation Damping Device for Twin Screw Refrigeration Compressor

Performance Investigation of a Pressure Pulsation Dampener Applied in the Discharge Chamber of a Twin Screw Refrigeration Compressor

Pulsation Damping of the Reciprocating Compressor with Helmholtz Resonator

Compressor Stability at Pulsating Condition Via Gas Dynamics Responses Analysis

Experimental Study of Lubricating Oil Impact on Pressure Pulsation for Twin-Screw Refrigeration Compressor

Investigation of characteristics of discharge pressure pulsation in a twin-screw refrigeration compressor

Noise control of a twin-screw refrigeration compressor

Noise control of a two-stage screw refrigeration compressor

Study on Damping the Pressure Pulsation in the Valve Chamber of Reciprocating Compressor Using the Helmholtz Resonator

Experimental Investigation on the Noise Reduction of an Axial Piston Pump Using Free-Layer Damping Material Treatment

Theoretical and Experimental Study on the Performance of Hermetic Diaphragm Squeeze Film Dampers for Gas-Lubricated Bearings

Numerical Simulation and Experimental Investigation on Attenuating the Pressure Pulsation of Reciprocating Compressor Using the Helmholtz Resonator

Attenuation of Gas Pulsation in the Valve Chamber of a Reciprocating Compressor Using the Helmholtz Resonator

Experimental Research on the Performance of a Refrigerant Generating Bubble Pump Based on a Diffusion Generation Process with H2O HCOOK-R134a

Characteristicsx and Suppression of NVH in Twin Screw Refrigeration Compressors

Experimental Research on the Performance of a Gas Lift Bubble Pump Based on a Diffusion Generation Process

Vibration and pressure pulsation elimination in a reciprocating compressor suction system using an acoustic filter

Attenuation Of Gas Pulsation In A Reciprocating Compressor Piping System By Using A Volume-Choke-Volume Filter

A Novel Damping Device for Broadband Attenuation of Low-Frequency Combustion Pulsations in Gas Turbines

Research on Performance of Refrigeration Centrifugal Compressor with Gas Bearings for Water Chillers

Research on Heat and Mass Transfer Characteristics of Water Lubricated Twin-screw Air Compressor