Abstract:As a highly efficient thick plate welding resolution, narrow gap gas tungsten arc welding (NG-GTAW) is in the face of a series of problems like inter-layer defects like pores, lack of fusion, inclusion of impurity, and the sensitivity to poor sidewall fusion, which is hard to be repaired after the welding process. This study employs numerical simulation to investigate the molten pool behavior in NG-GTAW root welding. A 3D numerical model was established, where a body-fitted coordinate system was applied to simulate the electromagnetic force, and a bridge transition model was developed to investigate the wire–feed root welding. The simulated results were validated experimentally. Results show that the molten pool behavior is dominated by electromagnetic force when the welding current is relatively high, and the dynamic change of the vortex actually determines the molten pool morphology. For self-fusion welding, there are two symmetric inward vortices in the cross-section and one clockwise vortex in the longitudinal section. With the increasing welding current, the vortices in the cross-section gradually move to the arc center with a decreasing range, while the vortex in the longitudinal section moves backward. With the increasing traveling speed, the vortices in the cross-section move toward the surface of the molten pool with a decreasing range, and the horizontal component of liquid metal velocity changes in the longitudinal section. For wire–feed welding, the filling metal strengthens the downward velocity component; as a result, the vortex formation is blocked in the cross-section and is strengthened in the longitudinal section.

Molten pool behavior of full penetration EBW on 2219 aluminum alloy

Numerical Investigation on Molten Pool Dynamics and Defect Formation in Electron Beam Welding of Aluminum Alloy

Numerical Simulation of Keyhole Morphology and Molten Pool Flow Behavior in Aluminum Alloy Electron-Beam Welding

Numerical Simulation Of Molten Pool Behavior In Electron Beam Girth Welding Of 2 Mm Niobium Plate

Numerical Simulation of Heat Transfer and Fluid Flow During Vacuum Electron Beam Welding of 2219 Aluminium Girth Joints

Numerical Simulation Of Periodic Fluctuation In Electron Beam Welding Pool

Numerical Investigation on Fluid Transport Phenomena in Electron Beam Welding of Aluminum Alloy: Effect of the Focus Position and Incident Beam Angle on the Molten Pool Behavior

Modeling and numerical study of the molten pool dynamics during scanning electron beam welding of aluminum alloys: Physical mechanism, prediction and parameter selection

Numerical Simulation Study of Electron Beam Welding of 2219 Aluminium Alloy

Modeling of Microstructure Evolution Coupled with Molten Pool Oscillation During Electron Beam Welding of an Al-Cu Alloy

Molten Pool State for Horizontal EBW on 3mm Niobium Plate

Numerical Analysis of Thermal Fluid Transport Behavior During Electron Beam Welding of 2219 Aluminum Alloy Plate

Molten pool flow behavior and influencing factors in electron beam selective melting of IN738 superalloy

Numerical Analysis of Fluid Transport Phenomena and Spiking Defect Formation During Vacuum Electron Beam Welding of 2219 Aluminium Alloy Plate

Molten flow simulation of laser deep penetration welding of aluminum alloys

Numerical simulation on molten pool behavior of narrow gap gas tungsten arc welding

Effect of Molten Pool Behaviors on Welding Defects in Tandem NG-GMAW Based on CFD Simulation

Molten pool behaviors and their influences on welding defects in narrow gap GMAW of 5083 Al-alloy

Dynamic Behavior of Molten Pool Backside During Full-Penetration Laser Welding of Ni-based Superalloys

Simulating molten pool features of shipbuilding steel subjected to submerged arc welding

Investigation of Molten Pool Behavior and Weld Bead Formation in VP-GTAW by Numerical Modelling