Abstract:Continuum manipulators have infinite degrees of freedom and high flexibility, making it challenging for accurate modeling and control. Some common modeling methods include mechanical modeling strategy, neural network strategy, constant curvature assumption, etc. However, the inverse kinematics of the mechanical modeling strategy is difficult to obtain while a strategy using neural networks may not converge in some applications. For algorithm implementation, the constant curvature assumption is used as the basis to design the controller. When the driving wire is tight, the linear controller under constant curvature assumption works well in manipulator position control. However, this assumption of linearity between the deformation angle and the driving input value breaks upon repeated use of the driving wires which get inevitably lengthened. This degrades the accuracy of the controller. In this work, the Koopman theory is used to identify the nonlinear model of the continuum manipulator. Under the linearized model, the control input is obtained through model predictive control (MPC). As the lifted function can affect the effectiveness of the Koopman operator-based MPC (K-MPC), a novel design method of the lifted function through the Legendre polynomial is proposed. To attain higher control efficiency and computational accuracy, we use a selective control scheme according to the state of the driving wires. When the driving wire is tight, the linear controller is employed; otherwise, the K-MPC is adopted. Finally, a set of static and dynamic experiments have been conducted using an experimental prototype. The results demonstrate high effectiveness and good performance of the selective control scheme.

Torque limit constrained control of redundant manipulator based on GWLN method

Torque Limitation Control of Industrial Manipulators Based on General Weighted Least Norm Method

General-Weighted Least-Norm Control for Redundant Manipulators

A Unified Weighted Least Norm Method For Redundant Manipulator Control

Clamping Weighted Least-Norm Method for the Manipulator Kinematic Control: Avoiding Joint Limits

Clamping Weighted Least-Norm Method for the Manipulator Kinematic Control with Constraints.

A Unified Approach for Second-Order Control of the Manipulator With Joint Physical Constraints

On the Virtual Joints for Kinematic Control of Redundant Manipulators with Multiple Constraints

Adaptive Robust Posture Control of A Pneumatic Muscles Driven Parallel Manipulator with Redundancy

Moving Obstacle Avoidance for Redundant Manipulator Via Weighted Least Norm Method

A lower dimensional task function method for point-to-point control of non-redundant manipulators

Adaptive robust posture control of a parallel manipulator driven by pneumatic muscles

Real-Time Flow Optimization of Hydraulic Manipulator with One Degree of Redundancy Considering Joint Limit Constraint

Trajectory Planning of Large Redundant Manipulator Considering Kinematic Constraints and Energy Efficiency

Torque optimization method of a 3-DOF redundant parallel manipulator based on actuator torque range

Homogeneous weighted motion planning for cooperated manipulator systems under position-torque constrained processing Environment

Robust adaptive wavelet network control for robot manipulators

Adaptive Neural-Network Boundary Control for a Flexible Manipulator with Input Constraints and Model Uncertainties

A Kinematics Control Scheme of Redundant Manipulators Under Unknown Loads or External Forces

Kinematic and Dynamic Models of Hyper-Redundant Manipulator Based on Link Eigenvectors

Robust Position Control of a Continuum Manipulator Based on Selective Approach and Koopman Operator