Vibration Response Analysis of Submerged Floating Tunnel in Dongwuyang Fiord in Normal Service Condition
Xiang Yiqiang,Gao Chaoqi,Shen Yonggang,Deng Liang
DOI: https://doi.org/10.1007/978-981-99-5922-8_35
2024-01-01
Abstract:Taking the channel to be built in Dongwuyang fiord as the engineering background, the conceptual design of the Dongwuyang channel project is propsed. It is the combination of a 100 m-long submerged floating tunnel (SFT) and a 570 m-long immersed tube tunnel. For the preliminary design of submerged floating tunnel, the length of every tube segment is taken as 100 m. There are 10 tube segments in total and the section of tube is hexagon-like. The tube segments are connected by the special joints, and each tube segment is tensioned by two groups of the paired anchor cables. The distance between the paired anchor cables is 50 m. Each group of paired anchor cables has four cables with an inclination angle of 45 degrees. The vibration response and internal force deformation of the SFT in Dongwuyang fiord are analyzed under the action of the dead load plus buoyancy, ambient wave, current load, and vehicle load. The calculation results show that the displacement and bending moment of the SFT tube body and the cable force of the anchor cables are the largest under the action of dead load and buoyancy, and the maximum vertical displacement value is 7.02 cm. The structural response under vehicle load is smaller than under dead load plus buoyancy, and the maximum vertical displacement value is only about 0.92 cm. Under the action of wave force with wave height H = 4.39 m, period T = 6.2 m, and wavelength L = 59.8 m in 100 years, the maximum horizontal and vertical displacement amplitude of the SFT tube body are 1.05 cm and 0.90 cm, respectively. Under the action of the maximum flow velocity of 1.33 m/s, the maximum mid-span vibration displacement of the SFT tube body is 2.1 mm. It shows that the SFT has sufficient dynamic stiffness under the combined action of live load (vehicle, wave, and current), and the flexural-to-span ratio of SFT is within l/2000-2500.