Abstract:This study systematically investigates the influence of the cross-sectional aspect ratio (B/H) and four different aerodynamic mitigation measures, i.e., the fairing, lower central stability plate, inverted L-shaped edge plate, and lower horizontal edge plate, on the performance of cable-stayed bridges, with π-typed composite deck, i.e., π section, due to vortex-induced vibrations (VIV). The study utilized wind tunnel tests and limited CFD simulations by varying bridge dimensions. First, based on a survey of existing cable-stayed bridges with the π-typed composite deck, three-section models with different aspect ratios were studied and their corresponding vibration characteristics for the vertical and torsional VIVs were analyzed. Then, the vibration suppression effects of mitigation measures with several variants in shape were investigated to determine an effective mitigation measure, i.e., with favorable aerodynamic stability, for the π section deck. The vibration suppression mechanism for three selected cases was further assessed using numerical simulation. The results show that: (a) for the π section model with the aspect ratio in the range of 9.05–11.96, increasing the ratio value will delay the onset wind speed of the vertical and torsional VIVs; (b) In the case of a low ratio of the torsional frequency to vertical bending frequency, there are often special phenomena where the vertical and torsional vibrations coexist. However, a larger aspect ratio would result in more independent vertical and torsional vibrations; (c) Regarding the vibration suppression effect, based on the limited studied cases, a small fairing can be superior to large fairings; (d) Different forms of the lower central stability plate have a good suppression effect on the vertical VIV; (e) The use of inverted L-shaped edge plate with a = <math>23</math>H and b = <math>12</math>H is identified to result in the best vibration suppression for both the vertical and torsional vibrations among the considered mitigation measures, where a and b are the size parameters of the inverted L-shaped edge plate; and (f) The lower horizontal edge plate cannot effectively improve the torsional VIV performance. This study offers guidance on the performance of composite cable-stayed bridge with the π section in isolation and equipped with mitigation measures to aid in the engineering design practice.

Vortex-induced vibration performance of a cable-stayed bridge with Π shaped composite deck and its aerodynamic control measures

Aerodynamic performance of Π-shaped composite deck cable-stayed bridges including VIV mitigation measures

Experimental and numerical studies of the vortex-induced vibration behavior of an asymmetrical composite beam bridge

Investigation of vortex-induced vibration of a cable-stayed bridge without backstays based on wind tunnel tests

Optimizing vortex-induced vibration suppression in π-shaped girders using wind tunnel testing and CFD analysis

Control of vortex-induced vibrations of a curved cable-stayed bridge by ECD-TMD

Study on VIV performance of streamlined steel box girder of a sea-crossing cable-stayed bridge

Experimental Study of Mitigation of Wind-Induced Vibration in Asymmetric Cable-Stayed Bridge Using Sharp Wind Fairings

Extraction of aerodynamic damping and prediction of vortex-induced vibration of bridge deck using CFD simulation of forced vibration

Vortex Dynamics-Based Flow Control of Wind Effects on Long-Span Bridges

Vortex-induced vibration performance and mechanism of long-span railway bridge streamlined box girder

Study on the Influence of Wind Fairing Parameters on the Aerodynamic Performance of Long-Span Double-Deck Steel Truss Suspension Bridge

Experimental and numerical study on vortex-induced vibration of a truss girder with two decks

Numerical Simulation Research Considering the Influence of Bridge Deck Cross Slope on Wind Performance of π-Type Composite Beam Cable-Stayed Bridge with a Symmetric Elevation Arrangement

Lateral buffeting control of long-span cable-stayed bridge deck by viscous dampers

Vortex-induced Vibration and Control of Split Three-Box Girder Bridges

Measures to Control Vortex-induced Vibration for Shangba Branch Channel Bridge in Nanjing

Experimental study on suppressing vortex-induced vibration of a long-span bridge by installing the wavy railings

Numerical simulation of vortex vibration in main girder of cable-stayed bridge based on bidirectional fluid–structure coupling

Mitigation Measures of Vortex-Induced Vibration of Suspension Bridge Based on Section Model Test

Modelling of vortex-induced force and prediction of vortex-induced vibration of a bridge deck using method of multiple scales