Abstract:Aimed at addressing the difficult problems existing in extremely low speed calibration facilities for hot-wire anemometers, where calibration accuracy is often insufficient and vulnerable to the contamination from temperature and humidity discrepancies between the calibration environment and the application environment, a calibration rig with a velocity range from 0.10 m/s to 1.0 m/s, an air temperature range of ambient temperature to 60 °C, and a humidity range from 20%RH to 80%RH was designed, developed, and constructed. The overall layout arrangement and the mechanical structure of the facility are illustrated. The master control system, the motion control system, the temperature and humidity control system are designed, tested and adjusted. The adjustment results are demonstrated and discussed. The analysis of the results reveals that the maximum velocity control error is 0.000989 m/s, satisfying the design target of 0.003 m/s; the corresponding maximum relative error is 0.241%, which is less than the design target of 0.4%; the maximum temperature control error is 0.9 °C, meeting the design target accuracy of 1 °C; the maximum humidity control error is 2.9%RH, which is below the design target of 4%RH. When the facility is applied to the calibration of a hot-wire anemometer, the maximum error of the fitting curves in modified King’s law is 0.02236 m/s, while that in Van der Hegge Zijnen’s formula is 0.023217 m/s, both of which satisfy the design target accuracy of 0.03 m/s. The maximum relative errors of fitting curves using the two formulas are 5.214% and 8.527%, respectively. Analysis of calibration data reveals that the discrepancy in temperature and humidity between application site and calibration site may bring errors that can reach up to 1.2676% per unit relative humidity discrepancy, and 5.672% per degree Celsius of temperature deviation, respectively.

Study on verification environment based on the influence of anemometer standard value

Development of Small-sized and Direct-current Calibration Wind Tunnel

NUMERICAL SIMULATION AND TEST INVESTIGATION OF WIND PRESSURES ON ROOF OF JINGGANGSHAN AIRPORT BUILDING

A Calibration Facility for Hot-Wire Anemometers in Extremely Low Speed with Air Temperature and Humidity Variable and Controllable

Performance of a Vehicle-Mounted Anemometer under Crosswind: Simulation and Experiment

Measuring Instrument of Atmospheric Environment Factors Based on Ultrasonic Velocimetry

Uncertainty Evaluation for Wind Speed Measurement Part (2): "Input quantity correlation"

A novel soft intelligent calibrator for low-velocity hot bulb anemometers

Experimental Study of Hot-Sphere Anemometer Response in Stratospheric Environment

Development of a Kind of Instrument Simulating Wind Speed

Investigation on Near-surface Wireless Wind Speed Profiler Based on Thermistors

C8051 F341-based Intelligent Anemometer Study

Correction of Field-Measured Wind Speed Affected by Deterministic Interference Factors

An angle-of-attack correction method for a 2-D miniature differential pressure solid-state anemometer

Study on temperature characteristics and correction of strain gauge balance in actual airflow environment

Research and development of mine high precision wind speed sensor and temperature correction

Biases in wind speed measurements due to anemometer changes

Development of Starting Wind Speed Calibration System

Design and Error Analysis on Pressure Measurement System of Low Speed Pressurized Wind Tunnel

A Cylindrical Vehicle-Mounted Anemometer Based on 12 Pressure Sensors—Principle, Prototype Design, and Validation

The impact of wind speed measurement method on MRT and PET values in limited air flow conditions on warm, sunny days