Abstract:High vacuum multilayer insulation (HV-MLI) cryogenic pipes which are used to transport low-temperature media (e.g.LNG) are often in a cryogenic environment with internal fluid pressure,so they will bear complex loads due to the effect of thermal-structural coupling.For investigating the response of each part in an HV-MLI cryogenic pipe under complex loads,the thermal-structural coupling finite element model was established based on a certain L-shape HV-MLI cryogenic pipe of horizontal-vertical trending.Then,the distribution of pipe temperature fields in different operating conditions,and the stresses on inner tubes,outer tubes,thermal bridges,bellows and thermal insulation supports and their variation in different loads were calculated.The following findings were obtained based on the above mentioned analysis.First,thermal insulation supports and thermal bridges are the main parts that affect heat leakage of pipes.In the case of LN2 transportation,for example,the heat leakage at thermal insulation supports and thermal bridges accounts for about 49.07％ and 49.32％ of the total pipe heat leakage,respectively.Second,inner tubes,outer tubes,elbows and thermal bridges are very safe when they are in service since their stresses are relatively small and lower than the material yield limit.Third,the stress on bellows increases with the decrease of the transportation medium temperature and the increase of compensation inner tube length.The bellow in a horizontal section is the most dangerous part of the whole pipe due to its higher stress.And fourth,the internal pressure on inner tubes is the main factor impacting the stress of thermal insulation supports.With the increase of the internal pressure on inner tubes,the stress on thermal insulation supports in horizontal and vertical pipe sections,which is the closest to the elbow,increases significantly,but the stress on thermal insulation supports,which is far away from the elbow,doesn't change greatly.Therefore,it is necessary to increase the thickness of thermal insulation supports close to the elbow and reduce the thickness of thermal insulation supports far away from the elbow in order to guarantee the strength as well as to reduce heat leakage.

Study on On-line Testing of Heat Leakage in Cryogenic Heat-insulation Pipeline

Simulation and analysis of dynamic heat transfer inside a cryogenic valve under cryogenic test

Pressure test method of safety assessment on existed submarine pipeline

Experimental study on the leakage temperature field of buried CO2 pipelines

Study on Measurement Accuracy of State Parameters in Leakage Process of Supercritical CO2 Pipeline

Diagnosis of the single leakage in the fluid pipeline through experimental study and CFD simulation

A study on the actual heat leak of a cryogenic vessel during storage

Study on Online Monitoring Test of Pipeline Leak Detection Transmission by using Optical Fiber Sensing Technology

Study on Piping Leakage of Dam with Limited-Length Line Heat Source Model and Experiment

The Studying of Online Leak Sealing Technology with Fluid Diversion and Welding on Gas Pipeline

Thermo-structural coupling analysis on L-shape HV-MLI cryogenic pipes

Leakage detection method of underground heating pipeline based on improved wavelet threshold function

A Leak Detection System for Valves Cooled to 20 K while Cooled with a GM Cryocooler

Evaluation and Optimization of Insulation Status Test for Primary Heating Network

Pipeline Leakage Monitoring Experiments Based on Evaporation‐enhanced FBG Temperature Sensing Technology

Study on temperature field distribution and leakage point localization of buried carbon dioxide pipeline leakage

Subsea Pipeline Hybrid Thermal Insulation with Phase Change Material and Aerogel – Analysis and Experiments

Leak Simulation for Liquid Pipelines

Investigation of heat leakage calculations and experiments for a wide-mouth liquid nitrogen tank

Research on Cryogenic Loop Heat Pipe Technology

Characteristics of heat fluxes of an oil pipeline armed with thermosyphons in permafrost regions