Abstract:Sintering behaviour of ashes from combustion of coal and biomass blends was experimentally investigated with a focus on the effect of ash preparation method. Blends of a Chinese anthracite, Jincheng coal, and two biomass materials, a wheat straw and a pine sawdust, respectively, were subjected to three different ash preparation procedures, namely, a low temperature oxygen plasma ashing device operating at ca 150 degrees C, combustion in a Muffle furnace at 815 degrees C and in a drop tube furnace at 1500 degrees C. The resulting ash samples were then subjected to the sintering temperature measurement using a pressure-drop sintering device, morphological and mineralogical characterisation using scanning electron microscope (SEM) fitted with X-ray energy dispersive spectroscopy (EDS) and X-ray diffractometry analyser (XRD), respectively. For the same coal and biomass blends but different ash preparation methods, the sintering temperatures were always the lowest for the ash samples from the plasma ashing device and the highest from drop tube furnace. SEM imaging showed that the texture of ash samples from the plasma ashing device was irregular, loose and more fibrous, indicating little interactions among the different mineral and inorganic constituents in the individual fuels. The muffle furnace and drop tube furnace ashes were denser and more uniform in shape as the mineral matter and inorganics became fused together. In addition, the drop tube furnace ashes were mostly in spherical-shape, indicating ash melting had occurred during combustion. The XRD analysis revealed that different minerals were present in the ash samples due to different ash preparation temperatures, with high temperature minerals present in the drop tube furnace ash. Biomass addition in the blends lowered the sintering temperature of corresponding ash; the higher the proportion of biomass in the blend, the lower the ash sintering temperature regardless the ashing method. At the same biomass addition ratio, the ash sintering temperature of the blend with the wheat straw addition was lower than that with the pine sawdust addition, because the wheat straw had a higher K and Cl content but lower Ca than the pine sawdust. The EDS and XRD analyses confirmed that the ashes of coal/wheat straw blends contained more K-bearing minerals, while the ashes of the coal/pine sawdust contained more Ca and K-bearing minerals. Both Ca and K-bearing minerals reacted with other minerals in the ash to form low temperature eutectics, leading to the reduction of sintering temperatures of the coal and biomass blends. However, the melting points of the K-containing minerals are higher than the Ca-containing minerals, therefore, the sintering temperatures of ash with the wheat straw addition were lower than those with the pine sawdust addition. (C) 2016 Elsevier Ltd. All rights reserved.

Research on Compound Binder of Long Flame Coal Briquette

Carbonization Temperature and Time Improving Quality of Charcoal Briquettes

High Strength Clean Briquettes Production from Long‐flame Coal Fines by Using Polyvinyl Alcohol and Coal Slime As Binders

Experimental Researches on Composite Bentonite-Based Briquette Binder

Bonding Mechanism of Binder and Low-Rank Coal During Carbonization

Study of an Organic Binder of Cold-Bonded Briquettes with Two Different Iron Bearing Materials

Orthogonal Experimental Study On Lime Shaft Furnace Briquettes As A Coke Substitute

Study on Briquette for Gasification and Boiler by Ueing Kailuan, Liujiang, Datong Fine Coal

Investigation Of Coal Tar Pitch Binder For The Production Of Formed Coal Briquettes For Corex From High Volatile Coal Powder

Study on the Strength of Cold-Bonded High-Phosphorus Oolitic Hematite-Coal Composite Briquettes

Coal Tar Pitch and Molasses Blended Binder for Production of Formed Coal Briquettes from High Volatile Coal

Experimental Study on Briquette Coal Sample Mechanics and Acoustic Emission Characteristics under Different Binder Ratios

Effect of Binders on the Crushing Strength of Ferro-Coke

Effect of molecular carbon structures on the evolution of the pores and strength of lignite briquette coal with different heating rates

Experimental method for optimizing the molding conditions of hot-pressed briquette

Evaluation and Optimization of Preparation for Semi-Coke Briquette with Alkali-Heat Treated Wheat Straw Binder

Effect of Ash Preparation Method on the Sintering Characteristics of Ashes from Combustion of Coal and Biomass Blends

STUDY ON OPTIMAL RATIO AND INDEXES OF THREE-COMPONENT BRIQUETTE WITH OIL-BASED DRILLING CUTTINGS

Effect of Biomass Ashes on Sintering Characteristics of High/low Melting Bituminous Coal Ash

Effect of binder composition on the preparation of formed coke with low-rank coal

Co-combustion, Co-Densification, and Pollutant Emission Characteristics of Charcoal-Based Briquettes Prepared Using Bio-Tar As a Binder