Abstract:For intelligence brakes in the electronic pneumatic brake system of commercial vehicles, the pressure change rate is used as the key control parameter and evaluation index. This can improve the brake safety, stability, and ride comfort of the vehicle. The real-time detection of the brake pressure change rate for commercial vehicles is the premise for realizing the accurate control of brake pressure change rate. Based on Poiseuille’s law, an efficient measurement method of brake pressure change rate is proposed for commercial vehicles, and a new measuring device with an isothermal container and laminar flow resistance tube as the core components is designed. Through thermal insulation performance tests, flow resistance tests and measurement accuracy tests, combined with simulations, the effects of structural parameters and copper wire filling density on the performance of the isothermal container are analyzed, and these key parameters are optimized to improve the thermal insulation performance. A tubular laminar flow resistance tube composed of 304 stainless steel capillaries in parallel is designed. The influence mechanism of core parameters such as the number, radius, and length of laminar flow channels on its performance is studied, and the optimal parameter array is selected to optimize its performance. The experimental platform for measuring brake pressure change rate is constructed. By comparing the measurement curve of brake pressure change rate under simulation and experiment, the correctness and effectiveness of the pressure change rate measurement principle and the key components for electronically controlled pneumatic brakes of commercial vehicles are verified to meet engineering requirements.

RESEARCH ON PRINCIPLE AND PERFORMANCE OF METER-IN, METER-OUT INDEPENDENT REGULATED BASED ON PRESSURE DECREASE SENSING

Research on Digital Control of Meter-In and Meter-Out Independent Regulating for High Inertia Load

Research on electro-hydraulic proportional load sense separate meter in and separate meter out control system

Design of High Pressure Reduction with Expander Pneumatic System' s Controller

Research on dynamic performance of independent metering valve-cylinder system based on double pressure compound control

Analysis of compressed air braking process under variable inlet pressure

Synchronization Strategy Research Of Pneumatic Servo System Based On Separate Control Of Meter-In And Meter-Out

Experimental Study on Air-Hydraulic Brake System

Strategy for Flow and Pressure Control of Electro Hydraulic Proportional Separate Meter In and Separate Meter Out Control System

Pump/valves coordinate control of the independent metering system for mobile machinery

Analysis of Pressure and Flow Compound Control Characteristics of an Independent Metering Hydraulic System Based on a Two-Level Fuzzy Controller

Calculation Force Control Based On Linearization Feedback Model Of Separate Meter In And Separate Meter Out Control System

Modeling of Separate Meter in and Separate Meter out Control System

Precision Motion Control of Separate Meter-In and Separate Meter-Out Hydraulic Swing System with State Constraints

Self-Tuning Pressure-Feedback Control by Pole Placement for Vibration Reduction of Excavator with Independent Metering Fluid Power System

Characteristics Study of Electro-Hydraulic Load-Sensing Control System for Mobile Machines

High Precision Energy Saving Motion Control Of Hydraulic Cylinder Based On Integration Of Valves And Pump

Simulation Of Separate Meter In And Separate Meter Out Control Of Electro Hydraulic Load Sensing System

Braking Force Decoupling Control Without Pressure Sensor for a Novel Series Regenerative Brake System

Research on Measurement Principle and Key Measuring Devices of Pressure Change Rate for Electronically Controlled Pneumatic Brake of Commercial Vehicle Based on Poiseuille’s Law

Constraint Performance Slip Ratio Control for Vehicles with Distributed Electrohydraulic Brake-by-wire System