Abstract:To solve the problem of the control accuracy in electrohydraulic loading systems caused by load increment, this paper proposes a multi-cylinder electrohydraulic digital loading (MEDL) technology for accurate reproduction of large load. A traditionally used single cylinder loading (SCL) is replaced by a new hydraulic cylinders group that includes N hydraulic cylinders at each point, in which one is controlled by the electrohydraulic servo valve and the others (N-1) are controlled by the on-off valve. The areas of the on-off valve controlled (OVC) cylinders form an increasing geometric sequence with a common ratio of 2. In addition, the force of the servo valve controlled (SVC) cylinder can be regulated continuously, and the OVC cylinders have only two states of no force or maximum force. There should be no force tracking error caused by nonlinear factors for the OVC cylinders. Thus, a continuous accurate large loading can be achieved by changing the working area of the cylinders group. Moreover, an improved full closed-loop (FCL) control strategy is proposed to solve the load reverse sudden change caused by the asynchronous opening and closing of the servo valve and on-off valve. With a case of N = 4 for MEDL, AMESim simulation results illustrated that the tracking error of the 4-cylinder group was about 1/6 of the single cylinder under a case of 40 kN. Furthermore, extensive experiments conducted on a real full loading bench under the FCL control method indicated that compared with SCL, the tracking error of the 4-cylinder group with a multi-step signal and various-frequency sinusoidal signals were reduced by 73% and 46%, respectively. Both simulation and experimental results proved that the proposed MEDL technology improved the loading accuracy and optimized the dynamic performance of the system.

Digital Electronic Truck Scale Partial Load Error Compensation Method

Truck Scale Partial Load Error Compensation Design

A Dynamic Voltage Compensation Method for Improving Weighing Accuracy

Graded Error Compensation Method for Heavy-Load Manipulators Based on Laser Tracking Measurement

Study on Dynamic Weighing System Base on Intelligent Algorithm

Study on Calibration Method and System Error Compensation of Balancing Machines

Weighing Fusion Method for Truck Scales Based on Prior Knowledge and Neural Network Ensembles

Error Analysis and Compensation for Load Cells Based Glue Mixing & Dosing Precise System Micro-D

Experimental Analysis on the Effectiveness of Kinematic Error Compensation Methods for Serial Industrial Robots

A Dynamic Weighing Method for Vehicle Scales Based on System Identification

RESEARCH ON COMPENSATION FOR VARIABLE DEAD-ZONE CHARACTERISTIC OF ELECTRO-HYDRAULIC PROPORTIONAL DIRECTION VALVE IN POSITION CONTROL

Zero-point Fault Detection of Load Cells in Truck Scale Based on Recursive Principal Component Analysis and Comprehensive Evaluation Method

Research on Attitude Compensated Algorithm for Shipborne Dynamic Weighing

Multi-cylinder electrohydraulic digital loading technology for reproduction of large load

Sensor signal high accuracy digitization and parameters optimization technologies

Real-time online detection of trucks loading via genetic neural network

A signal processing method for dynamic weighing system by SSA-LVQ network

Weighing fusion compensation method of temperature drift for electronic analytical balance

Structural design and analysis for U type dynamic electronic truck scale

Networked high-precision and high-stability array electronic belt scale instrument

Line-element based nonlinear adaptive piecewise compensating correction for LVDT sensors