Abstract:As a newly emerged active flow control technique, micro blowing/suction has shown a great potential in reducing the skin friction of turbulent flows. Throughout comprehensive analyses of active flow control of micro blowing/suction devices for a NACA0015 airfoil by means of CFD technique, the effects on various characteristics such as lift and drag coefficients and separation areas are investigated in this study. The control devices were placed at 12%c, 30%c and 70%c from the leading edge (c is the chord length of the airfoil), respectively. The corresponding trends of flow separation control at these locations were analyzed with a varied range of angle of attacks (AOA). The two- and three-dimensional incompressible unsteady detached-eddy simulation (DES) was used, along with the k-e turbulence model, in solving the flow problem. The numerical computational results have demonstrated that: (1) Installing micro blowing/suction devices near the separation point is more efficient, as blowing can mix the jet flow and the incoming flow to energize the turbulent kinetic energy and suction can mitigate the flow of low turbulent kinetic energy, which leads to a result of reducing the separation. (2) Suction sometime has more effective influence than blowing, when the flow control devices are placed at 12%c and 30%c. When the control device is placed at 70%c, the effects of lift enhancement and drag reduction are almost the same regardless of blowing and/or suction method. When the AOA is less than 18°, both methods can achieve the goal of lift enhancement and drag reduction. When the AOA is larger than 18°, neither blowing nor suction is efficient. (3) The 3-D numerical simulation shows that the vortex structure evolves from a 2-D pattern near the separation point to a 3-D pattern in the downstream. However the characteristics of flow separation control over a 3-D airfoil simulation agrees well with 2-D numerical results. (4) Blowing at 30%c can move the separation point downstream from 70%c to 80%c at AOA=11°.

Mechanism of Active Flow Control Using Micro Actuators

Micro Balloon Actuators for Active Flow Control

Aerodynamic Research of Actuator in Flow Control

Effects of Micro Blowing/suction Flow Control Devices on a NACA0015 Airfoil

Two MEMS Actuators for Application-Oriented Active Control of Flow Separation

Research of a MEMS Balloon Actuator

ADVANCES OF ACTIVE FLOW CONTROL BASED ON MEMS TECHNOLOGY

Numerical study of the effectiveness of using a single micro-jet actuator to vector primary flow

Exploring Application of Micromachined Actuators to Controlling Leading-Edge Vortices

Advanced Flow Measurement and Active Flow Control of Aircraft with MEMS

Flow Control of High-Speed Airfoil by Dielectric Barrier Discharge Plasma Actuator

Control effect of balloon actuator for flow field and structure of aerofoil

Study on Control Mechanism of Asymmetric Vortices over Slender Body Using MEMS Device

Flexible Balloon Actuators for Active Flow Control

Numerical Investigation by Applying Microballoon Actuators on High-Altitude Propeller

Experimental Research on Active Control of Separation Flow over Airfoil

Numerical Analysis Of Active Flow Control Around Airfoil By Synthetic Jet Technology In Low Reynolds Number

Modulation of driving signals in flow control over an airfoil with synthetic jet

Characteristics of a Synthetic Jet Actuator and Its Application on Control of Flow over a Backward Facing Step

Flow Control of Airfoil Dynamic Stall Based on DBD Plasma Actuators

Laminar-Separation-Bubbles Flow Control over Airfoil Using SDBD Plasma Actuator