Abstract:In this study, a thermo-mechanical finite element model was developed to investigate the thermal deformation during a stamping process of an automotive body part. The stamping process was decomposed into the 6 sub-steps to reflect the physical boundary conditions found in an actual stamping equipment. The temperature distributions of the actual stamping process were measured by two thermography cameras. The developed numerical procedure was then validated against the measured temperature distributions. Due to the limited accessibility to the actual equipment and high reflectivity of the involved material, the reflectivity index for the thermal imaging device (i.e., emissivity) was experimentally determined. A sample specimen made of the same material with the die material was built. The thermocouples were placed underneath the specimen surface through holes and used to directly measure the surface temperature distribution. The emissivity for the sample specimen was then determined by comparing the temperature measured by the thermocouples to the temperature measured by the thermographic camera. When the lubrication oils were spread on the sample specimen, the emissivity was set to a value 0.7. The thermal images were corrected based on the emissivity experimentally obtained and used to validate the finite element model simulation for the stamping process. With the validated finite element model, the investigation on the variation in the temperature and stress during each sub-step was performed. With the zero thermal expansion rate, the pure thermal effect on the temperature distribution was simulated. The pure thermal deformation in the Blank (i.e., target surface) was similar to the spring back distance after the blank was released from the molds. During the stamping process, the heat generation was obtained due to either friction between surfaces and plastic deformation of the target surface. We found that the plastic deformation played a critical role in the final temperature rise.

Numerical Simulation Analysis of Complete Stamping Process for Stiffener Part of Automotive Beam

Study on Simulation of Stamping Forming and Die Surface Optimization of Aluminum Alloy Plate

Study on Machining Deformation of Aircraft Monolithic Component by FEM and Experiment

Development of Drawing Die for Heat-Shield Panel of Automobile Engine Based on Finite Element

Thermo-mechanical coupled simulation of hot stamping components for process design

Numerical modeling of the thermal deformation during stamping process of an automotive body part

Finite Element Simulation of Two Stroke Deep Drawing in Sheet Metal Forming

Die Structure Analysis Of Stress Distribution During High-Strength Steel Stamping Process And Experimental Validation

FEM model optimization study of mechanical properties and material selection in stamping process

Numerical Simulation of Microstamping Process to Fabricate Multi-channel of SUS304 Thin Sheets with Consideration of Grain Structures

Improving the Accuracy of Stamping Analyses Including Springback Deformations

Simulation of Automotive Components to Optimize Best Application from Different Grades of Steel Using Finite Element Method (FEM)

The Finite Element Simulation of Stamping Process for Steel Wheel Spoke

Numerical Simulation and Process Improvement of a Typical Car Thread Plate

Digital Twin-Driven Sheet Metal Forming: Modeling and Application for Stamping Considering Mold Wear

FEM analysis of the extrusion-forging compound process for knuckle of Benz heavy truck

Stamping Process Optimization for the Rear Part of Door Inner Pane(lContinued 1)

Numerical and experimental verification of an iterative coupling method for analyzing the Lorentz-force-driven sheet metal stamping process

Mould Correction for Sheet-Metal Multi-Step Incremental Air-Bending Forming Based on Close-Loop Control and FEM Simulation

Implementation of finite element analysis for solving the constraints in forming process of large steel parts

Experimental and Numerical Method for the Analysis of Warm Titanium Sheet Stamping of an Automotive Component