Abstract:The SO2/NOX pollution in the flue gas of non-ferrous smelting is increasingly serious. At the same time, the accumulation of red mud (RM) in the aluminum industry and phosphorus sludge (PS) in the yellow phosphorus industry has caused serious harm to the environment. To remove SO2 and NOX from the non-ferrous smelting flue gas and realize the resource utilization of the above two solid wastes, an ultrasonic field was used in this study to strengthen the PS excited O3 process and RM wet desulfurization and denitrification process. In the process of O3 excitation, the response surface method (RSM) is used to obtain the optimal O3 excitation concentration, and the optimal reaction conditions are designed based on the response surface optimization model: T is 53.226 °C, power density is 0.4 W/cm2, PS concentration is 51.433 g/L, O3 formation concentration up to 250 ppm or more, which provides a theoretical basis for subsequent desulfurization and denitrification steps. It is proved that this study can replace the expensive traditional O3 generator and provide a basis for NOX removal in the following process. In addition, the optimum experimental conditions of ultrasonic enhanced RM desulfurization and denitrification process were also explored. Under ultrasonic frequency of 28 kHz, ultrasonic power density of 0.4 W/cm2, T of 50 °C, RM concentration of 15 g/L, and stirring intensity of 1000 rpm, the desulfurization efficiency of the reaction system can be maintained above 95 % within 250 min, and the denitrification efficiency can be maintained above 90 % within 250 min. The effect of desulfurization and denitrification in this study is much better than that of traditional methods. Finally, the reaction mechanism of ultrasonic enhanced O3 excitation and RM wet desulfurization and nitrogen removal was discussed by combining adsorption thermodynamics, isotherm, and kinetics. The results showed that the OH· free radicals generated by ultrasonic cavitation and the physical effects brought by emulsification had significant promoting effects.

DEVELOPMENT PROSPECT OF WET FLUE GAS DESULFURATION TECHNOLOGY BY USING MgO IN OUR COUNTRY

A Semi-Wet Technological Process for Flue Gas Desulfurization by Corona Discharges at an Industrial Scale

Recovery of SO2 and MgO from By-Products of MgO Wet Flue Gas Desulfurization.

Mechanism and technology of recovery flue gas desulphurization with magnesium oxide

Technical and economic feasibility analysis of recovery flue gas desulphurization with magnesium oxide

Ultrasonic-enhanced Phosphorus Sludge Excited O3 Coupled Red Mud Simultaneous Desulfurization and Denitrification

Experiment and Mechanism Analysis of Desulfurization with a MgO-Based Desulfurizer Fixed Bed Method

TECHNOLOGY OF WET DESULFURIZATION OF FLUE GAS

Studies of the Flue Gas Desulfuration in Magnetically Stabilized Fluidized Beds by Catalyzed Oxidation

Technical and Economic Comparison on WFGD and ACD Desulphurization Technology

Manganese Ore-based Wet Flue-Gas Desulfurization: A Review

Research on wet flue gas desulfurization by waste

Experimental Study of Limestone/Gypsum-based Wet Process Flue Gas Desulfuration

Desulfurization Technical for Flue Gas of Boiler in Large Coal Fired Power Plant

A Model for Performance Optimization of Wet Flue Gas Desulfurization Systems of Power Plants

A NEW PROCESS OF SIMULTANEOUS REMOVAL OF SO_2 AND NO_X FROM FLUE GAS WITH PYROLUSITE SLURRY

Development of the flue gas desulfurization

Flue Gas Desulphurization Based on Limestone-Gypsum with A Novel Wet-Type Pcf Device

Test Studies and Theorical Analysis of the Flue Gas Desulfuration in Magnetically Fluidized Bed

Application and experimental investigation of compound additive enhanced wet flue gas desulfurization process

Research on Improvement of Seawater Flue Gas Desulfurization Technology