Abstract:The aim of this paper is to investigate the sensorless voltage control schemes for the promising wound-rotor brushless doubly-fed induction generator (BDFIG) in both the stand-alone and grid-connected systems. For sensorless target, a new rotor position observer using the space vector flux relations of BDFIG is suggested. The proposed sensorless algorithm does not require any additional observers for obtaining the generator speed by directly detecting the rotor position, which may reduce the cost of the overall control system. For the voltage control purpose, a direct voltage control (DVC) scheme is applied for the stand-alone systems. However, this control strategy did not handle the control of the generated-voltage phase angle and also did not consider the phase sequence issue which are very essential provisions for the smooth connection target in grid-connected applications. Hence, DVC strategy cannot guarantee all the intended provisions for a soft and smooth connection process with the grid side and therefore, an effective grid-synchronization algorithm is proposed. A comprehensive analysis to confirm the functionality of the proposed control strategies is discussed through both simulation and experimental results. The presented study in this paper verifies the efficacy of the proposed schemes for sensorless voltage control target of BDFIG in both the stand-alone and grid-connected applications with a good transient behavior.

Sensorless Control Strategy of Doubly-Fed Induction Generator Connected to DC Grid

Sensorless Operation Technique of Doubly-Fed Induction Generator Connected to DC Grid Through Two Full Controlled Converters

Autonomous Operation Control Technique of DFIG Under Unbalanced Load

Sensorless Control Strategy for Multiphase Induction Motor with Stator and Rotor Resistance Identification Based on Injecting Third Harmonic Current

Sensorless control of permanent magnet synchronous generator in direct-drive wind power system

Novel DC Grid Connection Topology and Control Strategy for DFIG-based Wind Power Generation System

A Simplified Stator Frequency and Power Control Method of DFIG-DC System Without Stator Voltage and Current Sensors

Speed-sensorless Control for Grid-Connected Doubly-Fed Induction Generators Based on Virtual Synchronous Generator

Sinusoidal Current Operation of a DFIG-DC System Without Stator Voltage Sensors

Coordinated control strategy for doubly-fed induction generator with DC connection topology

Sensorless Voltage Control Schemes for Brushless Doubly-Fed Induction Generators in Stand-Alone and Grid-Connected Applications

Coordinated Control of DFIG System Based on Repetitive Control Strategy under Generalized Harmonic Grid Voltages

Improved MRAS Observer and Sensorless Control of DFIG During Network Voltage Unbalance

Direct Power Control of Doubly Fed Induction Generator Without Phase-Locked Loop in Synchronous Reference Frame During Frequency Variations

Independent Operation of DFIG-Based WECS Using Resonant Feedback Compensators under Unbalanced Grid Voltage Conditions

Stator Voltage Oriented Variable-parameter Control Strategy for Wind Turbine Driven Doubly Fed Induction Generator

A Control Strategy for Doubly-fed Induction Generator Wind Turbines under Asymmetrical Grid Voltage Conditions Caused by Faults

Low-Complexity Model Predictive Stator Current Control of DFIG under Harmonic Grid Voltages

Direct Power Control of Doubly Fed Induction Generator under Distorted Grid Voltage

Coordinated control strategy of DFIG for balanced currents and constant torque during grid voltage unbalance

Improved grid connection operation of type-III wind turbine under unbalanced fundamental and distorted grid voltages