Abstract:Three typical methanol-gasoline blends M10, M20, and M85 containing 10%, 20%, and 85% of methanol by volume, respectively, were used to investigate the effects of different methanol/gasoline ratios on engine power, thermal efficiency, and emissions, especially the exhaust methanol emission. A three-cylinder, port fuel injection engine was applied. Experimental results show that the engine power/torque ratio under the wide open throttle condition mainly depends on the amount of heat delivered to the engine. The addition of methanol significantly improves the brake thermal efficiency, while the methanol/gasoline ratio has a slight effect on it. Engine out CO and NOx emissions decrease with the increase of the methanol/gasoline ratio. The use of M85 leads to a reduction of CO and NOx by about 25% and 80%, respectively. A gas chromatograph is calibrated and used to measure the methanol emission. Measurement indicates that the addition of methanol in gasoline results in an increase of the unburnt CH3OH emission. And its concentration is nearly logarithmically proportional to the cyclically injected quantity. Because the response of the flame ionization detector to methanol is 40% that of hydrocarbon, the total hydrocarbon emission of the engine is revised. The nonmethanol hydrocarbons that resulted from gasoline are less affected by methanol addition, while the methanol emission is controlled independently by the cyclic quantity of fuel methanol injection.

Study of Performance and Exhaust Emissions of a Gasoline Engine Fuelled with Gasoline/Dimethoxy Methane Blends

Engine Performance and Emissions of A Compression Ignition Engine Operating on the Diesel-Methanol Blends

Combustion and Emission Characteristics of a DI Diesel Engine Fueled by Diesel-Methanol Blends

Engine performance and emission characteristics of a compression ignition engine fuelled with diesel/dimethoxymethane blends

Study on the Performance Experiment of Diesel Engine Operating on Diesel-dimethyl Carbonate Blends

Combustion and Emission Characteristics of a Compression Ignition Engine Fuelled with Diesel–dimethoxy Methane Blends

Investigation on Performance of a Spark-Ignition Engine Fueled with Dimethyl Ether and Gasoline Mixtures under Idle and Stoichiometric Conditions

Experiment of a gasoline engine fueled with gasoline-DMF blends and gasoline-alcohol blends

Performances of electronic fuel injection engine fueled with methanol-gasoline blended fuel

Effects of Methanol/Gasoline Blends on a Spark Ignition Engine Performance and Emissions

Effects of Methanol-Gasoline Improved Fuel on the Performance of Gasoline Engine

Study on the Performance and Emissions of a Direct Injection Diesel Engine Fuelled with Diesel/Ethanol Blends

Experimental Research on Gasoline Engine Fueled with DMF

An Experimental Study on the Performance of Emissions of Diesel Engines with Oxygenated Fuel

Investigation On Combustion And Emissions Of Dme/Gasoline Mixtures In A Spark-Ignition Engine

Study on the Emission Characteristic of Methanol-Gasoline Blend Fuel on EFI Engine

Experimental Study on Combustion and Emission Characteristics of a Lean Burn Engine Fueled with Methanol/Gasoline

Performance and Emission Characteristics of Diesel Engines Fueled with Diesel−Dimethoxymethane (DMM) Blends

Effect Of Dimethoxy-Methane And Exhaust Gas Recirculation On Combustion And Emission Characteristics Of A Direct Injection Diesel Engine

Performance and Emissions of a Direct-Injection Engine Fueled with Natural Gas/Hydrogen Blends

Experiment of combustion characteristics and emissions of gasoline-DMF blends