Abstract:This paper analyzes a recently introduced two-motor five-phase drive system with series connection of stator windings. It has been shown, using physical reasoning, that the introduction of an appropriate phase transposition in the series connection of two machines leads to a complete decoupling of the flux/torque-producing currents of one machine from the flux/torque-producing currents of the second machine. Consequently, independent vector control of the two machines becomes possible while using a single current-controlled five-phase voltage source inverter as the supply. The drive system modeling and control are first elaborated in this paper by taking both machines as induction motors. It is shown, using rigorous mathematical derivations, that the independent control of the two machines results due to the placement of machines in two different subspaces of the five-dimensional space. This is enabled by phase transposition in series connection. The models of the complete drive in the stationary common reference frame and in the rotor-flux-oriented reference frames of the two machines are developed. An associated vector control scheme for the two-motor drive is presented next. The second part of this paper describes an experimental setup used further on to evaluate the dynamic behavior of the two-motor drive. Performance is investigated by extensive experimentation for various transients (acceleration, deceleration, reversing, and disturbance rejection). Excellent decoupling of control of the two machines is achieved. Both the concept of the drive and the approach to modeling and control are thus fully verified experimentally. Finally, the advantages and shortcomings of the series-connected five-phase two-motor drive are discussed, and potential application areas are highlighted.

Research on a Inverter Topology for Dual-Motor Independent Control

Dual Closed-Loop Control Strategy on Harmonic Plane for Multiphase Induction Motor with Harmonic Injection Based on Air-Gap Flux Orientation Control

Investigation of Topology Evolution of Common-Mode-Voltage-Free SVPWM Multi-Leg Inverter and Motor Drive Performance

Research on Topology and PWM Control Method of a Three-phase Five-level Current-source Inverter

Research on Novel Open-End Winding Permanent Magnet Synchronous Motor Vector Control Systems

Research on Topology and PWM Method of a Single-phase Multilevel Current-source Inverter

Topology and control of multi-functional grid-connected inverter

Research on Matching of Motor Control System Based on Electric Drive of Engineering Vehicle

New independent control of a Bi Machine system powered by a multi-leg inverter applied to four in-wheel motor drive electric vehicle

High Performance Control of Matrix Converter Fed Induction Motor Drive System

Modeling, Control, and Experimental Investigation of a Five-Phase Series-Connected Two-Motor Drive With Single Inverter Supply

Research on Modulation Method of Five-Leg Inverter Fed Dual Induction Motor Drive System

Analysis on PWM Inverters Reliabilities and Novel Remedial Control Strategy for Fault-tolerant Topology

Modulation Techniques and Coordinated Voltage Vector Distribution: Effects on Efficiency in Dual-Inverter Topology-Based Electric Drives

Adaptive Nonlinear Control of High-Performance motors through Multi-Level Inverters

Research And Control Of Six-Phase Induction Motor Based On The New Topology

Control of A Dual-Stator Flux-Modulated Motor for Electric Vehicles

Comparative Research of MTPA-FW Control Strategy for IPMSM Used in Electric Vehicles

Modeling and Current Control Strategy for Novel Two-Phase DC-Biased Vernier Reluctance Machine

Vector Control Strategy Of A Four-Winding Motor With Flyback Topology

Synchronous Reluctance Motor Performance Improvement Using MTPA Control Strategy and Five-Level Inverter Topology