Numerical Investigation on Energy Ratios and Injection Strategies of an Ammonia-Diesel Dual-Fuel Marine Engine
Zewen Hu,Dongsheng Dong,Wenwen Wei,Hanyuyang Zhang,Feng Wei,Mengni Zhou,Gesheng Li
DOI: https://doi.org/10.1016/j.ijhydene.2024.05.092
IF: 7.2
2024-01-01
International Journal of Hydrogen Energy
Abstract:Ammonia (NH 3 ), as a carbon-free fuel, has gained widespread attention for its application in marine engines. A three-dimensional model of an ammonia-diesel dual-fuel marine engine was established and the effects of ammonia energy ratio (AER) and diesel injection strategies on the combustion and emission characteristics were analyzed. The results revealed that, for diesel single-injection strategy, as AER increases, the indicated thermal efficiency (ITE) decreases, NH 3 and unburned hydrocarbon (UHC) emissions increase, while both CO 2 and soot emissions decrease. With the increase of AER, the NO x emissions significantly decrease until AER = 0.5, then increase due to the fuel NO x dominant. Due to the large greenhouse gas effect of N 2 O, the greenhouse gas (GHG) emissions firstly increase and then decrease. Advancing the diesel injection timing (DIT) when AER = 0.4, NH 3 and soot emissions decrease, but CO, UHC and NO x emissions increase. Due to the low equivalence ratio and the low reactivity of NH 3 , the average cylinder temperature remains low, resulting in an increase of N 2 O and GHG emissions with DIT advances. However, Advancing DIT at AER = 0.8, NH 3, N 2 O and GHG emissions are closely associated with combustion efficiency. In addition, for the pre-injection strategy, at diesel pre-injection energy ratios of 0.2 and 0.4, as the diesel pre-injection timing (DIT pre ) advances, the homogeneity and ignition performance of the mixture improve, the combustion duration shortens, ITE improves, and NH 3 emissions decrease, but NO x , UHC and soot emissions increase. However, excessively advancing DIT pre reduce the ITE with more unburned NH 3 emissions. This may be attributed to the pre-injection diesel entering the crevice area, thereby reducing the pre-injection diesel in the cylinder and weakening its positive effect on the mixture. GHG emissions increase initially with the advancement of DIT pre , then fluctuate once the maximum average cylinder temperature reaches approximately 1630 K.