Abstract:<p>The 18,650 lithium-ion battery was charged and discharged at different rates, first in an environment with heat source, and then in one with heat-insulation, to study the effects of different thermal environments on the thermal behavior of lithium batteries. In the case of charging and discharging in adiabatic environments, the battery did not have thermal runaway, and the maximum temperature and temperature rise rate increased with the increase of the charging and discharging rates. During the 4 C discharge process, the resistance increased due to the action of the Positive Temperature Coefficient (PTC) element, and the loop current decreased, which made the highest temperature lower than that in the 3 C discharge process. In the presence of an external heat source, when charged and discharged at different rates, the battery was thermally out of control. The thermal runaway behavior of the battery during charging was a large amount of gas leakage. At the time of discharge, due to the high initial State of Charge (SOC), at the 0.5 C, 1 C, 2 C rates, there was thermal runaway following a large amount of gas leakage. The same phenomenon also occurred at the 3 C, 4 C rates, but without continuous combustion. In the environment of external heat source, results showed that the thermal runaway heat release was always greater in the charge process than in the discharge process. With the increase of the charge and discharge currents, the battery power before and after the thermal runaway remained almost the same. Therefore, the ratio of the thermal runaway heat release in the charge process to that in the discharge process kept increasing and finally approached 1.</p>

Simulation on the Temperature of Lithium-Ion Battery during Charge-Discharge Cycling

Simulation Study on Heat Generation Characteristics of Lithium-Ion Battery Aging Process

Simulation of li-ion battery's temperature field

Investigation the Degradation Mechanisms of Lithium-Ion Batteries under Low-Temperature High-Rate Cycling

Heat Transfer in the Dynamic Cycling of Lithium–titanate Batteries

Simulation of heat dissipation model of lithium-ion battery pack

Unlocking the Thermal Safety Evolution of Lithium-Ion Batteries under Shallow Over-Discharge

Investigation of Lithium-Ion Battery Nonlinear Degradation by Experiments and Model-Based Simulation

Insight into Heat Generation of Lithium Ion Batteries Based on the Electrochemical-Thermal Model at High Discharge Rates

Heat generation and thermal runaway mechanisms induced by overcharging of aged lithium-ion battery

Simulation and Analysis of the Temperature Rising for Cylindrical Power Batteries

A Thermal Runaway Simulation on A Lithium Titanate Battery and the Battery Module

Simulation and Experiment on Temperature Field of Lithium-ion Power Battery for Vehicle Based on Characteristic of Dynamic Heat Source

Electro-thermal Modeling and Experimental Validation for Lithium Ion Battery

Thermal Response of Lithium-Ion Battery During Charging and Discharging under Adiabatic Conditions

Experimental and Analytical Study on Heat Generation Characteristics of a Lithium-Ion Power Battery

Thermal Behavior Inside Lithium-ion Batteries

Revealing the Impact of Fast Charge Cycling on the Thermal Safety of Lithium-Ion Batteries

Numerical Study on Heat Generation Characteristics of Charge and Discharge Cycle of the Lithium-Ion Battery

Hazardous characteristics of charge and discharge of lithium-ion batteries under adiabatic environment and hot environment

Simulation of Active Air Cooling and Heat Dissipation of Lithium Battery Based on Comsol