Analysis and optimization of production conditions for 18F production using a medical cyclotron

Feng WANG,Jianhua YANG,Qing XIE,Shizhen ZHAI,Zhi YANG

DOI: https://doi.org/10.11889/j.0253-3219.2018.hjs.41.020301

2018-01-01

Nuclear Techniques

Abstract:[Background] Positron emission tomography/computed tomography (PET/CT) is a routine diagnostic method of particular importance for treatment evaluation and management in oncology. It is very important for PET/CT diagnosis to produce good quality and quantity positron nuclides using medical cyclotron. [Purpose] The effect of irradiation conditions and bombardment parameters on positron nuclide 18F production was analyzed to acquire the optimized production conditions and optimum bombardment parameters. [Methods] Origin 9.0 software was used to analyze the change of 18F yield with different proton beam current and bombardment time. Monte Carlo method was applied to establish the target chamber model of proton irradiation, and the proton energy, thicknesses of Havar foils and the 18O water were analyzed to obtain the optimum conditions of beam current, bombardment time and the proton energy,etc.[Results]Proton beam should thoroughly irradiate on target chamber center to make the best of beam current for triggering as much as nuclear reaction. When 20-MeV proton beam was used to produce 18F, the thicknesses of Havar foil and the target water were recommended to be 60 μm and 3 mm, respectively. Usually, the yield of 18F increases with the beam current. The longer the bombardment time was, the higher the yield of 18F. But with bombardment time increased, the trend of yield became slower. The bombardment time was suggested approximately 60 min. [Conclusion] It is necessary to select the appropriate thicknesses of Havar foil and the 18O water for positron radionuclide 18F production (this paper shows that the thicknesses of Havar foil and the 18O water should be 60 μm and 3 mm when the proton energy is 20 MeV). The irradiation time was suggested approximate 60 min to obtain high yield of 18F. Furthermore, irradiation should be started after the cyclotron run for a period of time for stabilization.