Abstract:The steam generator secondary emergency passive residual heat removal system (EPRHRs) is a new design for traditional generation II+reactor CPR1000. The EPRHRs is designed to improve the safety and reliability of CPR1000 by completely or partially replacing traditional emergency water cooling system in the event of the station blackout or loss of heat sink accident. The EPRHRs consists of steam generator (SG), heat exchanger (HX), emergency makeup tank (EMT), cooling water tank (CWT), and corresponding pipes and valves. In order to improve the safety and reliability of CPR1000, the model of the primary loop and the EPRHRs was developed to investigate residual heat removal capability of the EPRHRs and the transient characteristics of the primary loop affected by the EPRHRs using RELAP5/MOD3.4. The transient characteristics of the primary loop and the EPRHRs were calculated in the event of station blackout accident. Sensitivity studies of the EPRHRs were also conducted to investigate the response of the primary loop and the EPRHRs on the main parameters of the EPRHRs. The EPRHRs could supply water to the SG shell side from the EMT successfully. The calculation results showed that the EPRHRs could take away the decay heat from the primary loop effectively, and that the single-phase and two-phase natural circulations were established in the primary loop and EPRHRs loop, respectively. The results also indicated that the effect of isolation valve open time on the transient characteristics of the primary loop was little. However, the effect of isolation valve open time on the EPRHRs condensate flow was relatively greater. The isolation valves should not be opened too rapidly during the isolation valve opening process, and the isolation valve opening time should be greater than 10s, which could avoid the steam impact on the EPRHRs, and improve the stability of the system.

Experimental Research of Natural Circulation Characteristics in Secondary Side Passive Residual Heat Removal System

Experimental study on circulation characteristics of secondary passive heat removal system for Chinese pressurized water reactor

Experimental Investigation on the Heat Removal Capacity of Secondary Side Passive Residual Heat Removal System for an Integrated Reactor

Experimental Investigations On Temperature Distribution And Heat Removal Capability Of Residual Heat Exchanger

Development and Analysis of Passive Residual Heat-Removal System on Secondary Side of Small Reactor

Design and Transient Analyses of Emergency Passive Residual Heat Removal System of CPR1000

Research on the Designed Emergency Passive Residual Heat Removal System During the Station Blackout Scenario for Cpr1000

Heat transfer evaluation of natural convection outside the condenser in Passive Residual Heat Removal System of Molten Salt Reactor

Calculation Analysis on the Natural Circulation of a Passive Residual Heat Removal System for IPWR

Experimental Research and Theoretical Analysis of Flow Instability in Advanced Secondary Passive Residual Heat Removal System

Numerical Investigation on Heat Removal Capacity of Passive Residual Heat Removal Heat Exchanger

Numerical Study on Transient Characteristics of Passive Residual Heat Removal System

Thermal Hydraulic Analysis of a Passive Residual Heat Removal System for an Integral Pressurized Water Reactor

Assessment of Passive Residual Heat Removal System Cooling Capacity

Analysis of Secondary Emergency Passive Heat Sink's Ability to Relieve Accident of CPR1000

CFD investigation on start-up transient of HPR1000 secondary side passive residual heat removal heat exchanger

Study of the Behaviors of an Open-Loop Heat-Removal System

CFD Simulation of Secondary Side Fluid Flow and Heat Transfer of the Passive Residual Heat Removal Heat Exchanger

A Comparison of the RELAP5/MOD3 Code with the IIST Natural Circulation Experiments

Development of the Analysis Tool for the Water Cooling Type Passive Residual Heat Removal System of Chinese Pressurized Reactor

Preliminary Investigation of THFR Passive Residual Heat Removal System