Abstract:In a switchgear, an external transverse magnetic field (ETMF) is generated by the U type loop consisting of the vacuum interrupter, external busbar and conductive rod connected to the vacuum interrupter. The ETMF will make the vacuum arc deflected and strengthen the contraction of the arc. This can increase the probability of breaking failure. To weaken the adverse effect of the ETMF, the real magnetic field data of the arc area with different structure parameters when the length of conductive rod, external busbar and phase distance is changed are obtained by establishing simulation model in this paper. Taking the real magnetic field data as the boundary condition, this paper obtains the typical parameters of the vacuum arc plasma with different structure parameters by using the established three-dimensional high-current vacuum arc magnetohydrodynamics model. The simulation results show that the ETMF makes the transverse magnetic field (TMF) of the arc area asymmetric, which leads to an arc deflection. Reducing the length of the conductive rod connected to the vacuum interrupter to 50 mm can effectively improve the asymmetry of the TMF caused by the EMTF, weaken the arc deflection phenomenon, make the distribution of the plasma parameters more uniform, and increases the utilization of the anode contact surface. Moreover, it can not only reduce the heat flux density into the anode as a whole, but also reduce the heat flux density in the high heat flux density area, so as to effectively reduce the degree of anode activity and improve the negative effects caused by the anode activity. The changes of other external structural parameters have less influence on the improvement of the vacuum arc deflection phenomenon. Increasing the phase spacing to 275 mm or reducing the length of the external bus bar to 100 mm can only slightly weaken the arc deflection.

Influences of Arc Plate on Arc-quenching Performance of Bridge-shape Double-break Circuit Breaker

Simulation and Experimental Analysis of Arc Motion Characteristics in Air Circuit Breaker

Investigation on Arc Behavior During Arc Motion in Air DC Circuit Breaker

Study Of The Arc Motion Characteristics Of Low-Voltage Circuit Breaker Based On Magnetic Sensor Array

Numerical Investigation on the Influence of Circuit Breaker Structure Parameters on Vacuum Arc Behaviors

Experimental Study of Breaking Arc Characteristics for DC Miniature Circuit Breaker

Study on the effect of arc chamber structures on the post-arc characteristics of generator circuit breaker

Effect of Different Vent Configurations on the Interruption Performance of Arc Chamber.

Simulation On Arc Movement Under Effects Of Quenching Chamber Configuration And Magnetic Field For Low-Voltage Circuit Breaker

Study on Influencing Factor of Arcless Breaking in Hybrid Circuit Breaker

Numerical Analysis Of The Influence Of Splitter-Plate Erosion On An Air Arc In The Quenching Chamber Of A Low-Voltage Circuit Breaker

Study of Arc Interruption Characteristics under Rated Current in Low Voltage Circuit Breakers

An Arc Squeeze Method for DC Interruption—Experiments and Analysis

Simulation of the Venting Configuration Effects on Arc Plasma Motion in Low-Voltage Circuit Breaker

Effect of Back-Volume of Arc-Quenching Chamber on Arc Behavior.

Simulation Experiments and Research of Arc for Low Voltage Circuit Breaker

Medium-voltage Arcless DC Circuit Breaker Based on Arc Suppression

Numerical Research on Switching Arc of Circuit Breaker

Experimental Study on Arc Behaviors of a Bridge-Type Contact when Opening a Resistive Load in the Range of from 280VDC to 730 VDC

Experimental Study on Arcing Process of Vacuum Arc under Wan-Type Contacts

Research on the airflow field and interruption performance of 550 kV fast circuit breaker