Abstract:The converter controller model is the key part of a doubly-fed induction generator (DFIG) model.Because of the large number of controller parameters and the series connection between the PI controllers of inner and outer control loops,the traditional identification methods have some trouble with identifiability or engineering realization.A parameter identification method is proposed based on the disturbances made on the measurement signals of secondary side,which features multi-step identification and interactive iteration.The method separately makes disturbances on the measurement signals which are used as input of PI controllers in the converter control system.These disturbances can enlarge the effect of the triggered PI controller on the response of a DFIG.Therefore,parameters of the triggered PI controller can be identified by using its measurable control target as the observation.For the series connected PI controllers,the measurement signal disturbance will be made on the latter PI controller while shielding the change of the input measurement signal of the former PI controller. Thus,the decoupling identification can be carried out on the parameters of series connected PI controllers.Using the proposed method,the two parameters of each PI controller in the converter control system can be identified separately without any identifiability problem under the certain measurement signal disturbance.And the interactive iteration of identification can further improve the identification accuracy of total parameters.

PARAMETER IDENTIFICATION OF DC/DC POWER ELECTRONIC CIRCUITS BASED ON HYBRID SYSTEM MODEL

Parameter Identification of Power Electronic Circuits Based on Hybrid Model

Modeling and Parameter Identification of DC/DC Converters in Both CCM and DCM Mode

FAULT DIAGNOSIS FOR POWER ELECTRONIC CIRCUITS BASED ON HYBRID SYSTEM THEORYAND EVENT IDENTIFICATION

Parameter Estimation of Synchronous Generator Based on Park Model

Model parameter identification of DFIG based on short circuit current

Modeling and Control for DC-DC Converters Based on Hybrid System

Research on Parameter Identification of Buck Circuit

ON-LINE IDENTIFICATION OF POWER SYSTEM DYNAMIC EQUIVALENT Part Two Parameter Estimation & Simulation

Parameter Identification of the Synthesis Load Model Considering Distribution Impedance and Compensation Capacitor

Identification Approach to Dynamic Equivalents of the Power System Interconnected with Three Areas

On-line identification of power system dynamic equivalent: Part One: Models and Identifiability

Parameter Identification Method for Converter Controller of DFIG Based on Measurement Signal Disturbance

Identifiability Analysis of Load Parameters Based on Sensitivity Calculation

A hybrid data-driven modeling method on sensor condition monitoring and fault diagnosis for power plants

Parameter Designing of the DC Hybrid Circuit Breaker

Fault Diagnosis Based on Hybrid System Model and Filter for Power Electronic Circuits

Network Parameter Identification and Estimation Based on Hybrid Measurement of WAMS/SCADA

Dynamic State Estimation Enabled Health Indicator for Parametric Fault Detection in Switching Power Converters

The Simplifying For Peec Model Of Dc Bus Based On Parameter Sensitivity Analysis

Hybrid Data-Mechanism Modeling for Power Loss of a Boost Converter