Abstract:Means of measuring various parameters and technical characteristics of radio equipment have always occupied leading positions in science and technology. Without an accurate definition of the relevant values, it is impossible to build modern high-quality radio communication systems, radar, navigation ground and satellite systems. In ultrasound diagnostics, which are used in medicine, the speed of blood flow in vessels is studied by determining the frequency of the reflected signal. At the same time, it is necessary to use high-speed frequency measurement tools in systems with active sensors used in telecommunication networks based on Internet of Things technology. For example, in active radar, using the frequency of the reflected signal, it is possible to calculate not only the coordinates, but also the circular speed of the moving target. Modern research is aimed at improving the metrological and technical indicators of existing measuring devices, in particular at developing new methods for correcting the characteristics of the transformation of the measuring channel, which is their main component. At the same time, most digital frequency meters are built on the method of counting the number of pulses N with an unknown period Tx that arrive at the input of the device during a calibrated time interval. All this leads to an increase in measurement time and requires additional hardware costs for fast processing of measurement results. The coincidence method belongs to vernier methods and is promising for use when measuring the frequency of periodic signals. This paper points out the shortcomings of known methods of measuring the frequency of a periodic signal. On the basis of the well-known method of coincidence, a functional scheme of a 16-bit device for measuring frequency, which is implemented on the basis of a FPGA from Intel (Altera), has been developed. The developed coincidence frequency meter has a dynamic range of 96dB. Representation of time diagrams obtained in the Quartus Prime 18.0 automated design environment and confirming the operability of the developed functional scheme of the 16-bit device for frequency measurement by the coincidence method. An analytical dependence for determining the frequency of a periodic signal during frequency measurement by the coincidence method is presented.

Design of digital cymometer based on FPGA

Design of high precision frequency meter with FPGA

Digital Capacitance Measurement System Based on FPGA

Design of Multifunction Digital Clock Based on FPGA

Design of rf front end for cavity beam position monitor based on ics *

Design and Measurement of Signal Processing System for Cavity Beam Position Monitor

Design Of A Multi-Path Synchronous Frequency Meter With High Accuracy

Design of A High-Precision Component-Type Vertical Pendulum Tiltmeter Based on FPGA

A Low-Cost FPGA-Based Coarse-Fine Counting Time-to-Digital Converter With External High-Precision Reference Clock

Design of High-Accuracy Multiple-Function Dual-Path Frequency Meter

A 19 ps Precision and 170 M Samples/s Time-to-Digital Converter Implemented in FPGA with Online Calibration

A 1.6-Gsps High-Resolution Waveform Digitizer Based on a Time-Interleaved Technique

Design and Implementation of High-Precision Timing Module for NR Terminals Based on FPGA

Design of electronic clock and stopwatch based on FPGA and VHDL language

Design and Implementation of the Digital Detection Circuit for RFOG Based on a Single FPGA

IMPLEMENTATION OF THE COINCIDENCE FREQUENCY METER ON FPGA

A design of digital electronic clock

Design and Implementation of Simple Digital Oscilloscope Based on STM32

High-Resolution, Multi-Channel FPGA-Based Time-to-Digital Converter

Design of multi-channel synchronization signal acquisition method based on FPGA

High-precision time measurement electronics using the bandpass sampling method