Abstract:Power cables in the urban power supply system are laid in cable trenches or directly buried underground, and the insulation is susceptible to corrosion and penetration, causing local insulation aging or abrasion. Early detection of soft faults helps prevent power system faults from occurring. This paper proposes a method that can detect cable multi-point soft faults and distinguish fault types based on Frequency Domain Reflectometry (FDR). Firstly, we establish a numerical calculation model of distributed parameters to analyze the impedance spectroscopy characteristics of different types of defects and the positioning methods and errors. Next, a simulation study was carried out for different characteristics of aging and damage, which means different types of soft faults were successfully distinguished. Then, based on the results of the simulation, experiments are carried out to verify the effectiveness of the positioning algorithm and the feasibility of distinguishing defect types. Simulation and experiment show that the positioning error is within 0.5% and 1% simultaneously. Compared with traditional location methods, the defect location method proposed in this paper can determine the type and severity of the defect while locating multiple defects. The experimental results show that the defect identification method proposed in this paper has great potential for field application.

Design and Research on Distributed Parallel Test System for Airborne Cables

Design of Automatic Testing System for Whole Plane Aviation Cable

Design of CAN Bus Cable Testing System on Plane

An Electrical Multi-channel Distributed Test System of Aircraft Based on PXI Bus

Design of distributed wiring harness network test system based on the CAN bus

Research on On-Line Detection and Location Device for Aviation Cable Faults

Design and Implementation of Networked Distributed Test System for Aircraft Power Supply System

Cable Simulation System Design and Implementation for Offshore Oil Exploration

Research On Test Technologies Of Cable Faults

Design and Implementation of Remote Test System Based on Virtual Instruments

A Distributed High-Density Resistivity Meter Working on a Two-Wire Cable

The Design of Distributed Hardware Platform for Complex Electronic System Testing

Design of Network Transmission Delay Testing Software for Integrated Avionics System

Design of HV Power Cable Inspection System Based on Wireless Communication

Design of parallel test system based on ZigBee wireless networks

Development of a Testing system for detecting the Defect in Diagonal Bridge Cable

Testing Methods for Cyclic Fatigue of Distributed Sensing Cables

The Design of Embedded Cable Parameter Detection System Based on AVR

The Ground Test System Designed for Space-Borne Application

A Novel Method for Identifying Cable Defect and Improving Location Accuracy Based on Frequency Domain Reflectometry

A Panoramic Test System for Intelligent Substation Based on Wireless Time Synchronization Technology