Preparation and Properties of Rubber Nanocomposites Applied to High Performance Tires
WU YouPing,ZHANG LiQun
DOI: https://doi.org/10.1360/n972015-00867
2015-01-01
Abstract:The high performance tire with low fuel consumption and high wet skid resistance is the developing trend of tires in the world.Among the varied rubber composites comprising of tires,the rubber composites applied to tire tread,bead filler and inner liner are the keys to develop high performance tires.This review mainly introduces the preparation methods and properties of novel rubber nanocomposites for tires,and the future development trend is also suggested.Tire tread,which directly contacts the road,should meet the demands of low rolling resistance,high wet skid resistance and excellent abrasion resistance.The filler type,filler dispersion level and the filler-rubber interaction are important affecting factors for tire tread rubber composites.Now,silane-silica filled rubber nanocomposites are usually used as tire tread materials for high performance tires.This is due to the facts that silane-silica filled rubber nanocomposites exhibit lower rolling resistance and higher wet skid resistance than carbon black filled rubber nancomposites.The underlying mechanism was also discussed.To ensure the fine silica dispersion,in situ modification dispersion method is often applied during the industrial preparation process,and exact controlling in situ modification temperature is the key.In addition,liquid compounding method has attracted increasing attention.Further,new types of filler,such as carbon nanotube (CNT) and grapheme,can also be used in tire tread rubber nanocomposites,and the latest advances are mentioned.Bead filler,applied on the top of bead bundles,gives filling and reinforcing performance.Rubber nanocomposites used for bead filler should exhibit high modulus,high hardness,and excellent adhesion.Fibrillar silicate (FS) is composed of many fibrillar nanosized single crystals.Similar to silane-silica filled rubber composites,FS filled rubber composites can also be prepared by in-situ modification dispersion method to improve FS dispersion and interfacial interaction.Similar to the conventional short microfiber reinforced rubber,FS/rubber composites also exhibited high modulus,high tear strength,and anisotropy.It is worthy to note that FS filled rubber composites show better flow characteristics than short microfiber reinforced rubber.The potential of FS filled rubber nanocomposites used for bead filler was discussed.Innerliner,placed on the inner surface of tubeless tires,is to maintain the air pressure,and it requires that the rubber nanocomposite should have excellent gas barrier property.Clay,different from CB and silica,is of layered structure,and it can greatly improve the gas barrier property of rubber materials by its nanolayers.Clay can be dispersed on a nanometer level in rubber matrix by latex compounding method (LCM).LCM combines and fully makes good use of the two facts:(1) Many rubbers have their own latex form and latex can be considered as nanopolymer spheres dispersed in a water medium;(2) layered structural clay can be totally exfoliated by water.Further,for LCM,the organic modifier can also be added into the clay/water suspension to in situ modify the clay layers to improve interaction between clay and rubber matrix.And so,LCM is a low cost and easily controlled process.The clay/rubber nanocomposites prepared by LCM exhibit excellent mechanical and gas barrier properties,and they can be a good alternative for innerliner materials.Industrialized clay/rubber nanocomposites have been applied in tire inner liner,off the road tire tread and etc.For spherical and fibrillar types of filler,such as silica,FS and CNT,the fine dispersion and interfacial interaction can be achieved by in situ modification dispersion method;for layered fillers,such as clay and graphene,LCM is an effective method to obtain the fine dispersion and interfacial interaction.In the future,the applications of CNT and graphene filled rubber nanocomposites will largely depend on their preparation costs.