Abstract:Supercritical CO2 can be used as a heat transfer fluid in a solar receiver, especially for a concentrating solar thermal power tower system. Such applications require better understanding of the heat transfer characteristics of supercritical CO2 in the solar receiver tube in a high temperature region. However, most of the existing experimental and numerical studies of the heat transfer characteristics of supercritical CO2 in tubes near the critical temperature region, and the corresponding heat transfer characteristics in the high temperature region are conducted. In this paper, a three-dimensional steady-state numerical simulation with the standard k-ε turbulent model is established by using ANSYS FLUENT for the flow and heat transfer of supercritical CO2 in a heated circular tube with an inner diameter of 6 mm and a length of 500 mm in the high temperature region. The effects of the fluid temperature (823–1023 K), the flow direction (horizontal, downward and upward), the pressure (7.5–9 MPa), the mass flux (200–500 kg·m–2·s–1) and the heat flux (100–800 kW·m–2) on the convection heat transfer coefficient and Nusselt number are discussed. The results show that the convection heat transfer coefficient increases while Nusselt number decreases nearly linearly with fluid temperature increasing. Both fluid direction and pressure have negligible effects on the convection heat transfer coefficient and Nusselt number. Moreover, the convective heat transfer coefficient and Nusselt number are enhanced greatly with the increasing of mass flux and the decreasing of heat flux, which is more obvious at a higher heat flux. The influences of buoyancy and flow acceleration on the heat transfer characteristics are also investigated. The buoyancy effect can be ignored within the present parameter range. However, the flow acceleration induced by the high heat flux significantly deteriorates the heat transfer preformation. Moreover, eight heat transfer correlations of supercritical fluid in tubes are evaluated and compared with the present numerical data. The comparison indicates that the correlations based on the thermal property modification show better performance in the heat transfer prediction in the high temperature region than those based on the dimensionless number modification. And Nusselt number predicted by the best correlation has a mean absolute relative deviation of 8.1% compared with the present numerical results, with all predicted data points located in the deviation bandwidth of ±20%. The present work can provide a theoretical guidance for the optimal design and safe operation of concentrating solar receivers where supercritical CO2 is used as a heat transfer fluid.

Research on effects of foam filling types on heat transfer of supercritical CO2 flow in tube

Heat Transfer Characteristics of Supercritical CO2 Flow in Metal Foam Tubes

Numerical Investigation on Heat Transfer of Supercritical CO2 in Solar Receiver Tube in High Temperature Region

Experimental Study of Heat Transfer and Pressure Drop of Supercritical CO2 Cooled in Metal Foam Tubes

Numerical investigation on flow and thermal performance of supercritical CO2 in horizontal cylindrically concaved tubes

Performance analysis and comparison of different corrugated structures and a novel alternative elliptical twisted tube in supercritical CO2 tower solar receivers

Numerical Investigation of Different Heat Transfer Behaviors of Supercritical CO2 in a Large Vertical Tube

Effect study of super-critical CO<sub>2</sub> parameters on heat transfer performance of U-shaped double-pipe heat exchanger

Effect study of super-critical CO2 parameters on heat transfer performance of U-shaped double-pipe heat exchanger

Experimental and Simulation Investigation on Heat Transfer Characteristics of In-Tube Supercritical CO2 Cooling Flow

Thermal-fluid-mechanical analysis of tubular solar receiver panels using supercritical CO2 as heat transfer fluid under non-uniform solar flux distribution

Experimental investigation on convection heat transfer of supercritical CO2 in porous media

Comprehensive evaluation on the thermal-hydraulic performance of supercritical CO2/R41 in a micro-fin tube

Study on the convective heat transfer characteristics of supercritical CO 2 in mini-channels under unilateral heating conditions for application in a compact solar receiver

Thermal Performance Analysis on a Volumetric Solar Receiver with Double-Layer Ceramic Foam

Performance evaluation of a partially-filled porous foam cylindrical tubular receiver realizing Ni foam material reduction

Experimental Investigation of Convection Heat Transfer of CO2 at Super-Critical Pressures in Vertical Mini-Tubes and in Porous Media

Experimental and Numerical Study of Convection Heat Transfer of Co2 at Supercritical Pressures in Vertical Porous Tubes

Experimental Investigation on Convection Heat Transfer of Supercritical CO_2 in Porous Media

Forced Convection Heat Transfer of Supercritical CO2 in a Horizontal Circular Tube

Investigation And Modeling Of The In-Tube Heat Transfer Of Fluids At Supercritical Pressure During Heating