Abstract:In this paper, an exploration of the practical thermodynamic performance limits of the organic Rankine cycle (ORC) under working fluid and cycle parameter restrictions is presented. These performance limits are more realistic benchmarks for the thermodynamic cycle than the efficiency of the Carnot cycle. Subcritical ORC configuration with four typical case studies that are related to temperature ranging from 373.15 to 673.15 K is taken into account. The ORC is defined by its cycle parameters and working fluid characteristic properties. The cycle parameters involve evaporation temperature ( T eva ), condensation temperature ( T con ) and superheat degree (Δ T sup ), while the working fluids are represented by the characteristic properties including critical temperature ( T c ), critical pressure ( p c ), acentric factor ( ω ), and molar ideal gas isobaric heat capacity based on the principle of corresponding states. Subsequently, Pareto optimum solutions for obtained hypothetical working fluids and cycle parameters are achieved using multi-objective optimization method with the consideration of both thermal efficiency ( η th ) and volumetric power output (VPO). Finally, sensitivity analysis of the working fluid characteristic properties is conducted, and the second law of thermodynamics analysis, especially the applicability of entropy generation minimization, is performed. The results show that the current commonly used working fluids are widely scattered below the Pareto front that represents the tradeoff between η th and VPO for obtained hypothetical fluids. T eva and T con are the most dominant cycle parameters, while T c and ω tend to be the most dominant characteristic property parameters. The entropy generation minimization does not give the same optimal results.

Influence of pinch point temperature difference and fluid properties on trans-critical organic Rankine cycle

Analysis of a Combined Trilateral Cycle - Organic Rankine Cycle (TLC-ORC) System for Waste Heat Recovery

Comparison study of Trilateral Rankine Cycle, Organic Flash Cycle and basic Organic Rankine Cycle for low grade heat recovery

Parametric Study on Dynamic Behaviours of Basic Organic Rankine Cycle Recovering Waste Heat with Thermal Power Fluctuations

Effect of Fluid Dryness and Critical Temperature on Trans-Critical Organic Rankine Cycle

Multi-objective Optimization of Low Temperature Cooling Water Organic Rankine Cycle Using Dual Pinch Point Temperature Difference Technologies

Effects of Evaporator Pinch Point Temperature Difference on Thermo-Economic Performance of Geothermal Organic Rankine Cycle Systems

Thermodynamic analysis of working fluids: What is the highest performance of the sub- and trans-critical organic Rankine cycles?

Performance Analyses of Transcritical Organic Rankine Cycles with Large Variations of the Thermophysical Properties in the Pseudocritical Region

Prediction of the Roles of Critical Properties for Pure and Binary Mixture Working Fluid in Rankine Cycle Performances

Key Parameter Influence Mechanism and Optimal Working Fluid Screening Correlation for Trans-Critical Organic Rankine Cycle with Open Type Heat Sources

Performance Analysis of Double Organic Rankine Cycle for Discontinuous Low Temperature Waste Heat Recovery

Analysis of the Thermodynamic Performance Limits of the Organic Rankine Cycle in Low and Medium Temperature Heat Source Applications

Effect of Evaporation Temperature on the Performance of Organic Rankine Cycle in Near-Critical Condition

Correlation analysis based multi-parameter optimization of the organic Rankine cycle for medium- and high-temperature waste heat recovery

Working fluid selection for low temperature transcritical organic Rankine cycle

Analysis of the Quantitative Correlation Between the Heat Source Temperature and the Critical Temperature of the Optimal Pure Working Fluid for Subcritical Organic Rankine Cycles

Thermodynamic performance limits of the organic Rankine cycle: Working fluid parameterization based on corresponding states modeling

Selection and Evaluation of Dry and Isentropic Organic Working Fluids Used in Organic Rankine Cycle Based on the Turning Point on Their Saturated Vapor Curves

Modelling of Organic Rankine Cycle Efficiency with Respect to the Equivalent Hot Side Temperature

Performance Prediction and Working Fluid Active Design of Organic Rankine Cycle Based on Molecular Structure