Comparison of As(Ⅴ)Removal by Three Different Types of Ferric Iron Adsorbents

Qinqin Hu,Jun Zhou,Xueying Zhang,Zhiying Yan,Yuting Yang
DOI: https://doi.org/10.3969/j.issn.1009-0177.2014.06.013
2014-01-01
Abstract:In order to select economic and effective arsenic removal material,adsorption effect of pH and ratio between iron and arsenic on arsenic was studied first. Then releasing effects of reductive dissolution of iron-arsenic compounds on arsenic were also investigated. The results show that Fe (III)compounds was the best remover of As(Ⅴ),and the optimum pH ranged from 5 to 8. Meanwhile,it was found that the arsenic removal rate was increased with the increase of the ratio between iron and arsenic. When ferric chloride and ferric sulfate was selected as an adsorbent,the arsenic dissolution rate had an positively correlation with the Fe (III) reduction rate,and the correlation coefficient between them was up to 0.98 in the ferric sulfate solution. However,the correlation coefficient between arsenic dissolution rate and iron dissolution rates was lower than mentioned before when the Fe (III)appeared as solid oxide. Overall,the arsenic removal rates were ferric chloride > ferric sulfate > ferric oxide.
What problem does this paper attempt to address?