Inverse Gas Chromatography: Effects of the Experimental Temperature and Molecular Structure on the Solubility Parameters of 1-Alkyl-3-methylimidazolium Hydrogen Sulfate ([C n MIM][HSO 4 ], n = 4, 6, and 8)
Wenna Wang,Qiang Wang,Kaile Yu
DOI: https://doi.org/10.1021/acs.jced.0c00594
2020-10-19
Abstract:Thermodynamic parameters at infinite dilution for thirty-one organic solutes in a series of imidazolyl hydrogen sulfate ionic liquids (ILs) were determined by inverse gas chromatography (IGC). The IGC characterization was carried out at temperatures ranging between 303.15 and 343.15 K for determining the Hildebrand solubility parameter (δ<sub>2</sub>) as well as the Flory–Huggins interaction parameter (χ<sub class="stack">12</sub><sup class="stack">∞</sup>), the activity coefficient at infinite dilution (γ<sub class="stack">12</sub><sup class="stack">∞</sup>), and the thermodynamic functions. In addition, based on the γ<sub class="stack">12</sub><sup class="stack">∞</sup> results, the selectivity and capacity were directly calculated for two separation problems (hexane/benzene and hexane/thiophene). Under the different effects of the three ILs, it was found that the values of χ<sub class="stack">12</sub><sup class="stack">∞</sup> and γ<sub class="stack">12</sub><sup class="stack">∞</sup> were significantly different for the solutes tested, but all the values follow a certain pattern: they increase with temperature or decrease with temperature. As the temperature increased, the solubility parameters of the three ILs showed a linear decrease trend. The solubility parameters of the three ionic liquids at room temperature were obtained by extrapolation as δ<sub>2([BMIM][HSO4])</sub> = 24.15 MPa<sup>1/2</sup>, δ<sub>2([HMIM][HSO4])</sub> = 24.10 MPa<sup>1/2</sup>, and δ<sub>2([OMIM][HSO4])</sub> = 23.66 MPa<sup>1/2</sup>.The Supporting Information is available free of charge at <a class="ext-link" href="/doi/10.1021/acs.jced.0c00594?goto=supporting-info">https://pubs.acs.org/doi/10.1021/acs.jced.0c00594</a>.Origin and analysis of the solutes (Table S1); Flory–Huggins interaction parameter (χ<sub class="stack">12</sub><sup class="stack">∞</sup>) between solutes and ILs at various temperatures (Table S2); average experimental activity coefficients at infinite dilution for various solutes in three ILs at various temperatures (Table S3); the values of the limiting partial molar excess Gibbs free energies (Δ<i>G</i><sub class="stack">1</sub><sup class="stack"><i>E</i>, ∞</sup>), enthalpies (Δ<i>H</i><sub class="stack">1</sub><sup class="stack"><i>E</i>, ∞</sup>), and entropies (Δ<i>S</i><sub class="stack">1</sub><sup class="stack"><i>E</i>, ∞</sup>) for the solutes in the ILs at <i>T</i><sub>ref</sub> = 323.15 K (Table S4); Regression equations and correlation coefficients of three ILs of solubility parameter calculated by slope and intercept, respectively (Table S5); the Hildebrand solubility parameter of the ILs, δ<sub>2</sub> taken from the literature (Table S6); plot of the net retention volume (<i>V</i><sub>n</sub>) versus 1/<i>T</i> of [HMIM][HSO<sub>4</sub>] for various solutes: (a) <i>n</i>-alkanes, octene, dichloromethane, chloroform, carbon tetrachloride, ketones, and ethers and (b) aromatics, alcohols, acetonitrile, thiophene, tetrahydrofuran, carbon disulfide, and esters (Figure S1); plot of the net retention volume (<i>V</i><sub>n</sub>) versus 1/<i>T</i> of [OMIM][HSO<sub>4</sub>] for various solutes: (a) <i>n</i>-alkanes, octene, dichloromethane, chloroform, carbon tetrachloride, ketones, and ethers and (b) aromatics, alcohols, acetonitrile, thiophene, tetrahydrofuran, carbon disulfide, and esters (<a class="ext-link" href="/doi/suppl/10.1021/acs.jced.0c00594/suppl_file/je0c00594_si_001.pdf">PDF</a>)This article has not yet been cited by other publications.
engineering, chemical,thermodynamics,chemistry, multidisciplinary