Abstract:A reversed-phase chromatographic process is developed on a centrifugal platform to separate and collect water-soluble dyes from a mixture. A separation column filled with C18-reversed phase silica gel was used to separate the components from a mixture and the eluate was collected by a series of collecting chambers. The purified components can then be identified and extracted from the collecting chambers. The effects of the silica gel's particle size (7-10, 20-45, and 46-63 μm) and the platform's rotational speed (1000, 1500, 2000 RPM) on the separation and collection efficiency were investigated. Experimental results showed that dye separation could be well performed in the column with smaller-sized silica gels (7-10 μm) under a low rotational speed (1000 RPM). However, for the eluate collection, the high eluent flowrate and long processing time resulted in a convective band-broadening problem in the collecting chambers, which affected the recovery ratio of the dyes. Experimental results showed that the convective band broadening effect can be reduced by reducing the flowrate, shortening the collecting time, and switching the eluent to a different composition. The best recovery ratio of the dyes in the current design can be achieved by using the column with a powder size distribution of 46-63 μm and operating at the rotational speed of 1500 RPM. This platform can process a sample volume of 1 μL and the processing time is about 30 min. Since the only instrument used is a motor, the complete chromatographic process, from separation to fraction collection, can be carried out on a centrifugal platform at a low cost.

Chromatographic elution process of spiral countercurrent extraction device

RETENTION OF STATIONARY PHASE AND PARTITION EFFICIENCY OF MULTILAYER HELICAL COLUMN ROTATED AROUND ITS HORIZONTAL AXIS

Study on spiral tube continuous countercurrent extraction chromatography system

Improving the Operating Conditions of Gradient Ion-Exchange Simulated Moving Bed for Protein Separation

Spiral Tube Assembly for High-Speed Countercurrent Chromatography: Choice of Elution Modes for Four Typical Two-Phase Solvent Systems

Concentrical Coils Counter-Current Chromatography for Natural Products Isolation: Salvia Miltiorrhiza Bunge As Example.

Chromatographic elution process design space development for the purification of saponins in Panax notoginseng extract using a probability-based approach.

Full use of the liquid nature of the stationary phase: The development of elution‐extrusion counter current chromatography

Experimental investigation on separation characteristics of axial cyclone separator

Numerical study on the performance of swirl tube based on orthogonal design

Optimization of membrane dispersion ethanol precipitation process with a set of temperature control improved equipment.

Model for spiral columns and stationary phase retention in synchronous coil planet centrifuges

Comparison of experimental and simulated separation performance in capillary tube-in-manifold devices

Gas-liquid-liquid extraction in a novel rotating microchannel extractor

Numerical study on the effect of surface wettability on the falling film flow characteristics of the spiral wound tube heat exchanger

Separation of Chlorogenic Acid and Isochlorogenic Acid by Spiral Tube Fractional Extraction

Liquid chromatography on a centrifugal platform for separation and collection of water-soluble dyes

Progresses of study and application on extraction columns

Study on the experimental conditions in separating protein mixture by gel filtration

Liquid-liquid Microextraction in a Rotating Microchannel Extractor