Abstract:The interaction between particle density and cyclone size is crucial for selecting hydrocyclone size but not clearly understood. This paper presents a numerical study on the effect of particle density on the multiphase flows and performance of hydrocyclones with respect to cyclone size by the recently developed two-fluid model. The numerical results show that more ultrafine particles are misplaced to the underflow in smaller cyclones, which is pronounced for heavier particles. On the other hand, coarse light particles are more likely to unexpectedly report to the overflow in larger cyclones. Moreover, the handling of lighter particles gives rise to a decreased separation precision and an increased cut size. This result is consistent with the experimental observations and pronounced in large hydrocyclones. The inner flows and the forces acting on particles have been analysed in details. It is shown that the particle separation behaviors against particle density and cyclone size mainly attribute to two factors. One is the relative importance of the radial accelerations due to the centrifugal, pressure gradient and drag forces acting on particles, respectively. These accelerations collectively determine the radial motion of particles and thus their chance of entering the proper flow streams for separation. Another is the extent of particle accumulation near the spigot. Such accumulation reduces the separation space of hydrocyclone and blocks the ways of particles for separation, although it mitigates the water entrainment effect on ultrafine particles, to some extent. Based on the results from this study, a mid-range cyclone size is recommended to mitigate the adverse effect of particle density and obtain relatively precise particle separation on the condition that the expected cut size can be achieved. (C) 2016 Elsevier B.V. All rights reserved.

Structural parameter optimization of downhole dual-stage tandem hydrocyclone

Research on structural parameter optimization of a new axial inlet hydrocyclone separator based on response surface optimization method

Structural Parameter Optimization of Hydraulic Vertox Separator in Recirculating Biofloc Technology System Based on Computational Fluid Dynamics

Multi-objective optimization of a novel vortex finder for performance improvement of cyclone separator

Strengthened oil-water separation by swirl vane hydrocyclone based on short-circuit flow regulation

Effect of Structural Modification on Hydrocyclone Performance

Optimizing the Inlet Design of A Liquid-liquid Cylindrical Cyclone

Enhancement of the classification and recovery process of fine mineral particles via a newly developed volute feed hydrocyclone

Designing the hydrocyclone with flat bottom structure for weakening bypass effect

Design of an Axial Hydrocyclone for Preliminary Water Separation Using CFD, RSM, and SUS

Multi-objective Optimization of Hydrocyclone by Combining Mechanistic and Data-Driven Models

Optimization of the Structural Parameters of a Cyclone by Using a Genetic Algorithm

Structural Parameter Optimization of the Helical Blade of the Variable-Pitch, Downhole, Cyclone Separator Based on the Response Surface Method

Numerical Simulation Analysis of Main Structural Parameters of Hydrocyclones on Oil-Gas Separation Effect

Computational Analysis and Optimization of Hydrocyclone Size to Mitigate Adverse Effect of Particle Density

Effect of cone section combination form on the separation performance of a biconical hydrocyclone

Design of Downhloe Oil-Water Cyclone Separator and the Study of Laboratory Experiment

Numerical and experimental study on enhanced oil–water separation performance using hydrocyclone coupled with particles

Investigation on separation performance and structural optimization of a two-stage series cyclone using CPFD and RSM

Multi-objective optimization of axial-flow-type gas-particle cyclone separator using response surface methodology and computational fluid dynamics

LES analyses of flow fields and structure improvements of hydrocyclones