Abstract:Taxus mairei is an important source for industrial extraction of taxol in China. However, the standard and steps of extraction are currently not uniform, which seriously affects the taxol yield. In the present study, the influence of four factors (methanol concentration, solid-liquid ratio, ultrasonic extraction temperature, and ultrasonic extraction time) on the taxol yield was successively explored in T. mairei. A response surface methodology (RSM) was used to optimize the extraction process based on the single-factor experiments above. The optimal conditions were as follows: methanol concentration was 90%, solid-liquid ratio was 1:15 (g/mL), ultrasonic extraction temperature was 40 °C and ultrasonic extraction time was 60 min. Moreover, the twigs and needles from T. mairei with different tree ages were treated by the optimum extraction process, which further revealed temporal and spatial distribution of taxol in the reproducible tissues. Interestingly, the taxol content was relatively higher in needles of T. ‘Jinxishan’ (a cultivar from T. mairei with yellow aril, FY), but was less in FY twigs. The accumulation of taxol in twigs and leaves of females (with red aril, FR) was significantly higher than that of males (M); however, the content showed a decreasing trend with the increasing tree ages. Therefore, it is suitable to increase the proportion of female trees especially the FY leaves as raw materials for the industrial production of taxol from T. mairei, and the tree ages should be better controlled at 3–7 years.

Basic Study on Taxol Separation from the Organic Solvents in Two-Liquid-Phase Cultures of Taxus Cells

[The Extraction and Separation of an Active and Available Component from Taxus Mairei].

Extraction and Purification of 10-Deacetyl Baccatin Ⅲ from Taxus Mairei

[Study on Taxol Release in the Two-Liquid-phase Cultures of Taxus Cuspidata].

Optimization of Taxol Extraction from Taxus Baccata L.

Isolation and Purification of Bio-Active Polysaccharides from Leaves of Taxus Mairei

Kinetics of Two-Liquid-Phase Taxus Cuspidata Cell Culture for Production of Taxol

Isolation of Taxol,7-Epi-10-deacety Taxol,cephalomannine and the Isomerization of Taxol from 7-Epi-taxol

The Optimum Technology and the Selection of Pilot Scale Experiment Conditions of Preparation of the Taxol Extract from the Leaves and Branches of Taxus Media

A New Method for Isolating and Purifying Natural Drug Taxol

Analysis of Extracting Taxol from Different Parts of Planted Yew

Improved Production of Paclitaxel from Suspension Culture of Taxus Chinensis Var. Mairei by in Situ Extraction with Organic Solvents

Optimization of Taxol Extraction Process Using Response Surface Methodology and Investigation of Temporal and Spatial Distribution of Taxol in Taxus mairei

A Large Scale Separation of Taxanes from the Bark Extract of Taxus yunnanesis and 1H- and 13C-NMR Assignments for 7-epi-10-Deacetyltaxol

[Separation and Identification of Taxol in the Crude Extracts of Taxus Cuspidata and Its Callus Culture with HPLC-ESI-MS/MS].

Process Optimization of Supercritical Fluid Extraction of Active Ingredients in Taxus.

Preparative Separation And Enrichment Of Four Taxoids From Taxus Chinensis Needles Extracts By Macroporous Resin Column Chromatography

Improved Taxol production in suspension cultures of Taxus chinensis var. mairei by in situ extraction combined with precursor feeding and additional carbon source introduction in an airlift loop reactor

Purification of Taxol and Its Related Analogues by Supercritical CO2 Fluid Extraction

Optimization of the fractional precipitation of paclitaxel from a Taxus chinensis cell culture using response surface methodology and its isolation by consecutive high-speed countercurrent chromatography.

Extraction of Taxol from the Branches of Taxus Media with Supercritical CO_2 Carbon Dioxide