Abstract:The hygric performance of building envelopes determines the degradation progress. Multiple factors, including the climate parameters (e.g., solar radiation and wind-driven rain) and building structure (e.g., thermal bridges), significantly affect the hygrothermal conditions in building envelopes. Inappropriate thermal insulation measures may exacerbate the humidity within the building envelope and further induce condensation and mould growth, which threatens the building structural safety and indoor air quality. However, the key facilitators of moisture accumulation in building envelopes are yet to be fully determined. Herein, a well-validated coupled heat and moisture transfer (HAMT) model was adopted to investigate moisture accumulation in building envelopes. The target building was located in a Chinese city (Hangzhou) where the climate is characterized as a hot and humid summer and a cold winter. The results demonstrate that the moisture content as well as condensation and mould risk is closely related to the building wall orientation. High heat flux at the exterior surface can reduce the overall moisture content of the building envelope. Conversely, it could facilitate moisture accumulation when the building envelope is exteriorly isolated by a layer of thermal insulation material (e.g., expanded polystyrene). Subsequently, the insulation layer could increase condensation risk. Three prone periods for condensation as well as spore germination and mould growth in a year were detected, indicating that the conditions that are tendentious for the above risks are the same. The adoption of an external insulation layer could prevent mould from growing inward while increasing the condensation risk. (c) 2022 Elsevier B.V. All rights reserved.

Coupled Heat and Moisture Transfer Model and Simple Solution Method for Building Envelopes

Development Of Modeling For Coupled Heat And Moisture Transfer In Porous Building Envelope

Facilitator of moisture accumulation in building envelopes and its influences on condensation and mould growth

Simulation of Coupled Heat and Moisture Transfer in Air-Conditioned Buildings

Numerical Simulation of Coupled Heat and Moisture Transfer in Porous Building Material

Experimental Method for Coupled Heat and Moisture Transfer in Porous Building Envelope

Whole-Building Heat, Air, and Moisture Transfer Modeling for Residential Buildings in Different Climates

Simulation of Whole Building Coupled Hygrothermal-Airflow Transfer in Different Climates

The Analysis of Coupled Heat and Moisture Transfer in Building Envelop Based on Numerical Simulation

Numerical Investigation for Thermal Performance of Exterior Walls of Residential Buildings with Moisture Transfer in Hot Summer and Cold Winter Zone of China

Numerical Evaluation of Hygrothermal Behavior and Moisture Risk for Multi-layer Wall in the Hot and Humid Southern China Area

Coupled heat and moisture transfer in multi-layer building materials

Coupled Heat and Moisture Transfer in Building Material with Freezing and Thawing Process

Simultaneous Heat and Moisture Transport in Porous Building Materials: Evaluation of Nonisothermal Moisture Transport Properties

Analytical Methods to Calculate Combined Heat and Moisture Transfer in Porous Building Materials under Different Boundary Conditions

Two-Dimensional Hygrothermal Transfer in Porous Building Materials

Mathematical model and its validation of coupled heat and moisture transfer for multilayer wall

Numerical Simulation of Heat, Air, and Moisture Transfer Through a Wall of Porous Media

Establishment of Equivalent Coupled Diffusion Model for the Transfer of Heat and Mass in the Building Walls

Calculation Models And Frequency Analysis Of Moisture Transfer In Air-Conditioned Buildings

Development of an Analytical Method for Simultaneous Heat and Moisture Transfer in Building Materials Utilizing Transfer Function Method