Bioreactivity of Inhalale Particles and Analysis from Its Microscopic Characteristics

Jin-juan LI,Long-yi SHAO,Shu-shen YANG,Wei-jun LI,Hui LI
DOI: https://doi.org/10.3321/j.issn:0250-3301.2006.03.033
2006-01-01
Environmental Sciences
Abstract:Plasmid DNA assay was employed to investigate the bioreactivity of PM_(10) collected at urban site and suburban site Shangdianzi in Beijing in spring,2004.The results showed that the values of TD20(the dosage of PM_(10) that caused 20% DNA damage) of the two PM_(10) samples collected at Shangdianzi site were 53μg·mL~(-1) and less than 50μg·mL~(-1) respectively and that of the two PM_(10) collected at urban site were 125μg·mL~(-1) and 100μg·mL~(-1) respectively,showing that the bioreactivity of suburban PM_(10) samples was distinctly higher than that of urban PM_(10).Using high solution Field Emission Scanning Electron Microscopy(FESEM) and image analysis technology,analysis on the bioreactivity of PM_(10) from its microscopic characteristics was investigated and it seemed that there might two impossible reasons for the differences of bioreactivity: one was that finer particles which had relatively large surface area were the main parts in PM_(10) at Shangdianzi site,the number concentration in 0~0.7 μm scale and the surface area in 0~1.0 μm scale were much higher than that of urban PM_(10).The other reason was that the main component of PM_(10) at urban site was coarser mineral particles,otherwise,the main type of particle in PM_(10) at Shangdianzi site was soot which was considered to be more bioreactive,accounting for as high as 58.8%.Therefore,mass concentration is not the only index to assess the health effect of PM_(10),size distribution and particle type might play an important role in its bioreactivity.
What problem does this paper attempt to address?