A CFD simulation of the effect of street canyon configurations and wind dircetion on fine particulate matters dispersion
Jianfeng LIU,Baoqing WANG,Honghong NIU,Bowei LIU,Zihui REN,Ronghui CHEN,Zebei WANG
DOI: https://doi.org/10.15985/j.cnki.1001-3865.2017.04.005
2017-01-01
Abstract:The configurations of a real street canyon and wind directioon were considered to study their influence on the dispersion of fine particulate matters.The ratio of architecture height to street width (H/W) of street canyon,the gaps between buildings (ratio of the gap between buildings to the total length of the street) and wind dircetion were discussed.Computational fluid dynamics (CFD) software was used to simulate the detailed flow,turbulence characteristics and fine particulate matters dispersion distribution in street canyon.The results indicated the maximum fine particulate matters dispersion concentration of street central line were 37.5,46.4 and 28.4 μg/m3 for the site of street central line of-19.3,-88.0 and-19.3 m (at the distance from the center of the street,the positive value indicated east of the street center,while the negative value indicated west of the street center,and the same below),respectively when the gap between buildings was 20％,wind direction was north,wind speed was 3 m/s and H/W was 1 ∶ 2,1 ∶ 1 and 2 ∶ 1 at 1.5 m above ground.The maximum fine particulate matters dispersion concentration of street central line were 88.1,31.6 and 33.7 μg/m3 for the site of street central line of 148.0,-92.3 and-186.7 m,respectively when H/W was 1 ∶ 1,wind direction was north,wind speed was 3 m/s and the gaps between buildings were 0,20％,40％ at 1.5 m above ground.The maximum fine particulate matters dispersion concentration of street central line were 10.6,11.2 and 16.0 μg/m3 for the site of street central line of 165.3,58.0,1.5 m respectively,when H/W was 1 ∶ 1,the gap between buildings was 20％,wind speed was 3 m/s and wind directions were west,north and southwest at 1.5 m above ground.These results suggested that street canyon configuration and wind direction should he taken into account in modeling fine particulate matters dispersion.