Abstract:In this paper we describe potential impacts to groundwater quality due to CO2 and brine leakage, discuss an approach to calculate thresholds under which "no impact" to groundwater occurs, describe the time scale for impact on groundwater, and discuss the probability of detecting a groundwater plume should leakage occur. To facilitate this, multi-phase flow and reactive transport simulations and reduced-order models were developed for two classes of aquifers, considering uncertainty in leakage source terms and aquifer hydrogeology. We targeted an unconfined fractured carbonate aquifer based on the Edwards Aquifer in Texas and a confined alluvium aquifer based on the High Plains Aquifer in Kansas, which share characteristics typical of many drinking water aquifers in the United States. The hypothetical leakage scenarios centered on the notion that wellbores are the most likely conduits for brine and CO2 leaks. Leakage uncertainty was based on hypothetical injection of CO2 for 50 years at a rate of 5 million tons per year into a depleted oil/gas reservoir with high permeability and, one or more wells provided leakage pathways from the storage reservoir to the overlying aquifer. This scenario corresponds to a storage site with historical oil/gas production and some poorly completed legacy wells that went undetected through site evaluation, operations, and post-closure.For the aquifer systems and leakage scenarios studied here, CO2 and brine leakage are likely to drive pH below and increase total dissolved solids (TDS) above the "no-impact thresholds"; and the subsequent plumes, although small, are likely to persist for long periods of time in the absence of remediation. In these scenarios, however, risk to human health may not be significant for two reasons. First, our simulated plume volumes are much smaller than the average inter-well spacing (1-2.6 wells/km(2)) for these representative aquifers, so the impacted groundwater would be unlikely to be pumped for drinking water. Second, even within the impacted plume volumes little water exceeds the primary maximum contamination levels. These observations point to.The potential utility of uncertainty quantification methods to evaluate the risk of leakage and inform monitoring and corrective action plans of a potential site for long-term CO2 storage by capturing storage reservoir, leakage pathway, and aquifer heterogeneity.The importance of establishing baseline groundwater chemistry that captures the pre-injection variability of underground sources of drinking water (USDW) above the reservoir because the EPA has adopted a "no net degradation" policy toward the protection of groundwater resources.The need to test and develop spatially diverse monitoring techniques capable of detecting leakage early to employ effective mitigation strategies, and more importantly to add confidence to assessments used to evaluate the length of the post-injection site care. In our study, the probability of detecting plumes using existing wells to sample the groundwater chemistry was very low, because the plumes were relatively small in both aquifers.The need to develop methodologies that prevent and/or directly detect leakage prior to reaching USDWs, because our simulations predict that even small amounts of CO2 and brine, when left unmitigated, can change USDW pH and TDS concentrations for long periods of time. (C) 2014 The Authors. Published by Elsevier Ltd.

Factors Influencing Amount of CO2 Leakage through a Fault Zone in Deep Storage Aquifer

Influence of Highly Permeable Faults Within A Low-Porosity and Low- Permeability Reservoir on Migration and Storage of Injected Co2

Impact of Inner Reservoir Faults on Migration and Storage of Injected CO2

Uncertainty Quantification of CO 2 Leakage Through a Fault with Multiphase and Nonisothermal Effects

Effect of permeability anisotropy on the CO2 saturation distribution and phase change during a leakage event in a saline aquifer

Numerical Simulation of CO2 Leakage in a Shallow Subsurface Layer from a CO2 Geological Storage Site

Migration characteristics and local capillary trapping mechanism after the CO 2 leakage out of saline aquifers

Quantitative assessment of CO2 leakage risk in geologic carbon storage management

A mechanism of fluid exchange associated to CO2 leakage along activated fault during geologic storage

Evaluation of Caprock Sealing Performance for CO2 Saline Aquifer Storage: A Numerical Study

Key Indicators of Caprock Sealing Assessment with Consideration of Faults in Potential CO2 Geological Storage Sites in Subei Basin, China

Simulation of the Microscopic Seepage Process of CO 2 Storage in Saline Aquifers at the Pore Scale

Prediction on Leakage and Rate Characteristics of CO2 Storage

Evolution of Sealing Efficiency for CO2 Geological Storage Due to Mineral Alteration Within a Hydrogeologically Heterogeneous Caprock

Modeling of CO2 transport and pressure buildup in reservoirs during CO2 storage in saline aquifers: a case in Dongying Depression in China

Global Sensitivity Analysis of Leakage Risk for CO2 Geological Sequestration in the Saline Aquifer of Yancheng Formation in Subei Basin

CO2 Long-Term Diffusive Leakage into Biosphere in Geological Carbon Storage

Analysis of dynamic characteristics and influencing factors of CO2 low-permeability coal reservoir sequestration

Numerical Modeling of Self-Limiting and Self-Enhancing Caprock Alteration Induced by CO2 Storage in a Depleted Gas Reservoir

Key Factors for Determining Groundwater Impacts Due to Leakage from Geologic Carbon Sequestration Reservoirs

Analysis of CO2 Migration During Nanofluid-Based Supercritical CO2 Geological Storage in Saline Aquifers