Utilization of response surface modeling to optimize hydrogen peroxide and hydroxyl radicals generation by electro-Fenton with copper-foam as cathode

Guojun LI,Shan QIU,Yingshi ZHU,Fengxia DENG,Fang MA
DOI: https://doi.org/10.12030/j.cjee.201706051
2018-01-01
Abstract:Foam-metal used as cathode in electro-Fenton (EF) has attracted attention recently due to it threedimensional structure and good conductivity.In this study,copper-foam and graphite rod were used as cathode and anode,respectively.Moreover,micro-porous aeration glass reactor was designed,aiming for improving the low oxygen mass transfer rate in the EF configuration.The mechanism involved electro-generated active oxygen species (H2O2 and · OH) was investigated by response surface modeling method.The effect of the different parameters affecting the performance of active oxygen species generation was investigated,including pH,current density and initial ferrous concentration.Response surface modeling method,more specifically,Box-Behnken design (BBD) was used to optimize the above-mentioned parameters for active oxygen species generation and then to put forward polynomial models between these parameters and active oxygen species.Results show that significant polynomial models were obtained (RH22O2 =0.977 8,R2·OH =0.964 2) and optimal conditions was obtained from BBD were shown as follows:pH =2,ferrous concentration =15 μmol · L-1 and current =0.25 A for H2O2 generation,while pH =2,ferrous concentration =20 μmol · L-1 and current =0.25 A for hydroxyl radicals generation.The copper concentration released from copper-foam cathode ranged from 0.4 to 1.8 mg · L-1,lowering than the standard concentration (CJ 343-2010).
What problem does this paper attempt to address?