Abstract:The force equilibrium and moment equilibrium play a significant role on the sealing performance of gas split floating ring seals. A small deflection angle may generate seriously wear on sealing surface and cause seal failure. Therefore, the thermo-hydrodynamic lubrication analysis of gas split floating ring seal with Rayleigh grooves is investigated considering the deflection angle and frictional heat of surface contact, which is beneficial to grasp the hydrodynamic characteristics and rules under high-temperature and high-speed conditions. Pressure and temperature distributions of sealing rings are numerically calculated for the cases with different deflection angle, rational speed, seal pressure and ambient temperature. Then, the hydrodynamic effect and sealing performance are analyzed. The obtained results show that, the surface Rayleigh step grooves do not present obvious hydrodynamic effect when split seal ring has no deflection. While, a significant hydrodynamic effect can be obtained when the split seal ring presents a deflection angle about dozens of micro radians. Here, a 10% increase of opening force is achieved when the deflection angle reaches 80 μrad in the case of speed 30,000 r/min and seal pressure 0.2 MPa. Moreover, the hydrodynamic effect becomes obvious with increasing deflection angle as well as rotational speed. Meanwhile, the growth of rotational speed results in an obvious increase of film temperature. The increase of ambient temperature has a significant influence on the decrease of leakage rate. When the ambient temperature increases from 340 K to 540 K, the leakage rate reduces exceeding 50%, however, it does not present obvious effect on the opening force. The proposed model has the potential to provide the theoretical basis and design guidance for surface grooves of gas split floating ring seal in the future.

Effects of Structure Elasticity on Leakage and Rotordynamic Coefficients of Floating Ring Seals

Studies of Exit Pressure Recovery Coefficient and Its Effects on Dynamic Characteristics of Annular Water Seals

Numerical Calculation of Nonlinear Dynamic Characteristics for Labyrinth Seals

An Eccentric 3-D Fluid-Structure Interaction Model for Investigating the Effects of Rod Parallel Offset on Reciprocating-Seal Performance

Computational Analysis of Sealing and Stability of a Deformable Floating and Fixed Rings of an Annular Seal

Dynamic Coefficient Analysis of Labyrinth Seal Based on FLUENT

A Bulk-Flow Analysis of Static and Dynamic Characteristics of Floating Ring Seals

Semi-analytical Fluid-solid Coupling Model for Hydrostatic Mechanical Seals

Theoretical Analysis on Fluid-Structure Coupling of Hydrostatic Mechanical Seal

Analysis of Leakage Flow and Dynamic Characteristics in Floating Ring Seals for High Pressure Turbopump

Effect of Swelling Behavior of Rubber Rings on the Sealing Performance for 70MPA Hydrogen Pressure Reducing Valves

Research on internal flow field analysis and power loss modeling of the expansion seal ring

Elastic deformation of liquid spiral groove face seals operating at high speeds and low pressure

Dynamic coefficients of small cone-shaped annular seal rotor

Dynamic Characteristic Analysis of the Shallow Slot-Split Floating Ring Seal

Thermo-Hydrodynamic Effect of Gas Split Floating Ring Seal with Rayleigh Step Grooves

Rotordynamic characteristics prediction for scallop damper seals using computational fluid dynamics

Numerical Simulation on Rotordynamic Characteristics of Annular Seal under Uniform and Non-Uniform Flows

Performance Analysis of the Shallow Slot Split Floating Ring Seal

The effect of surface roughness on thermal-elasto-hydrodynamic model of contact mechanical seals

Study of annular seal flow inlet-loss coefficient and its influence on rotor system vibration characteristic