Abstract:The aim of this paper is to investigate the pressure wave propagation behavior in LOX/kerosene rocket engine pump pipeline. A pressure wave propagation model for gas–liquid two-phase flow with phase change taken into consideration is first proposed by using ensemble-averaging techniques. Then condensation of gas oxygen in subcooled liquid oxygen and the corresponding mixing process in pump pipeline are numerically simulated with the application of thermal phase change model in Computational Fluid Dynamics code CFX. Finally, based on the established model and the predicted flow parameters, pressure wave in gas–liquid pipeline flow, characterized by the propagation speed and the attenuation coefficient, is studied by personally compiled code on MATLAB. The calculation results indicate that the propagation speed of two-phase pressure wave first slightly falls and then increases with the decreasing void fraction along the flow direction, and the increase of angular frequency causes the propagation speed and the attenuation coefficient of two-phase pressure wave to increase. The vapor bubble diameter, mass flow rate and inlet temperature of gas oxygen are shown to have strong effects on the mixing flow condensation process of gas oxygen and liquid oxygen. Bubble with larger diameter can weaken the condensation process, and leads to greater cross-sectional mean void fraction of gas oxygen. This phenomenon results in an overall decrease in pressure wave propagation speed and an increase in attenuation coefficient except for the short slug-flow region located at the pipeline inlet. Similar effects can also be achieved by increasing the mass flow rate or the inlet temperature of gas oxygen.

Ideal Cycle Model for Laser Propulsion with Gas-Liquid Two Phase Propellant

ICOPE-15-C048 the Ideal Power Cycle Model for Laser Propulsion with Gas-Liquid Two Phase Propellant

Modeling of Three-Dimensional Exciplex Pumped Fluid Cs Vapor Laser with Transverse and Longitudinal Gas Flow

Ideal Thermodynamic Cycle of Thermoacoustic Effect With Liquid-Vapor Phase Change

Some Thoughts on Condensed Propellants for Laser Propulsion

Energy density effects on propulsive characteristics of water propellants for laser propulsion

Rotating Cavitation of the High-Speed Rotational Inducer of LPRE

Research Progress of Laser Propulsion with Liquid Propellants

Influencing Factors on Propulsive Performances of Water Droplets for Laser Propulsion

Transmitted laser propulsion in confined geometry using liquid propellant

High Coupling Coefficient Laser Propulsion Mode

Measurements of Impulse Coupling Coefficient for Laser Propulsion with Liquid Propellants

Reviews of the Propulsive Characteristics Study on Liquid Propellants for Laser Propulsion

Analytical and Numerical Study of the Air Breathing Model for Laser Propulsion

Mechanism analysis and numerical simulation of air-breathing model for laser propulsion

Mechanism for Water-Powered Laser Propulsion

Thermodynamic Cycle Performance for Water Ramjet Motors

Analysis on the Optimal Mixing Pressure and Efficiency Limit of an Ideal Ejector

Pressure Wave Propagation Characteristics in A Two-Phase Flow Pipeline for Liquid-Propellant Rocket

Investigation of Performance and Mechanism for Chemical Laser Propulsion

Effect of Nozzle Geometry on the Performance of Laser Ablative Propulsion Thruster