Abstract:In this paper, a servo motor operated rotary directional control valve is proposed, and a systematic analysis of steady flow torques in this valve is provided by theoretical calculation, CFD simulation and experimental test. In the analysis, spool rotation angle corresponding to the maximum orifice opening is tagged as 0 degrees. Over a complete change cycle of the orifice, the range of spool rotation angle is symmetric about 0 degrees. The results show that the direction of steady flow torques in this valve is always the direction of orifice closing. The steady flow torques serve as resistances to the spool rotation when the orifice opening increases, while impetuses to the spool rotation when the orifice opening decreases. At a certain pressure drop or flow rate, steady flow torques are approximately equal and opposite when at spool rotation angles which are symmetric about 0 degrees. When the spool rotates from 0 degrees, at a certain pressure drop, their values increase first then decrease with the spool rotation and reach their maximum values at an angle corresponding to about 1/2 of the maximum orifice opening, and at a certain flow rate, their values increase with the spool rotation. The steady flow torques in this valve are the sums of those in the meter-in and meter-out valve chambers. At a certain spool rotation angle, steady flow torques in the meter-in and meter-out valve chambers are approximately proportional to the pressure drop and the second power of the flow rate through the orifice. Theoretical calculation and CFD simulation can be validated by the experimental test. The proposed calculation formulas can predict the steady flow torques in the rotary directional control valve correctly. (C) 2015 Elsevier Ltd. All rights reserved.

Variable control flow supply angle regulation scheme of vortex valve solid rocket motor thrust modulation

Influence of Structural Parameters on the Performance of Vortex Valve Variable-Thrust Solid Rocket Motor

Steady Flow Torques in a Servo Motor Operated Rotary Directional Control Valve

Performance Comparison of Control Strategies for a Variable-Thrust Solid-Propellant Rocket Motor

Thrust Control Method and Technology of Variable-Thrust Liquid Engine for Reusable Launch Rocket

Flow Force Analysis and Structural Optimization of a Large Flow Rate Pressure Compensation Valve

Modeling and Parameter Sensitivity Analysis of Valve-controlled Helical Hydraulic Rotary Actuator System

Experimental investigation of a flow-oriented throttleable injector designed for throttleable hybrid rocket motor

Throttling simulation and control of liquid oxygen/liquid methane rocket engine pressurized by the electric pump

Variations and Control of Thrust and Mixture Ratio in Hybrid Rocket Motors

Simulation of Optimization of Variable Geometry for a Turbofan Engine of a Missile

Numerical investigation on thrust gain mechanism of helium injected solid–gas hybrid rocket motor

Pressure oscillation and suppression method of large-aspect-ratio solid rocket motors

Comparison Of Solid Rocket Motor Thrust Modulation Technique

Improved Design and Performance Analysis of Counterflow Thrust Vectoring Technology under High Subsonic.

System scheme design of electric expander cycle for LOX/LCH4 variable thrust liquid rocket engine

Flow Rate Adjustable Ratio Analysis of a Novel Control Valve with Double Sleeve

Numerical and Experimental Investigation on Opening Direction Steady Axial Flow Force Compensation of Converged Flow Cartridge Proportional Valve

Thrust Control of Lab-Scale Hybrid Rocket Motor with Wax-Aluminum Fuel and Air as Oxidizer

Cavitating Venturi as a Mass Flow Controller in a Deep Throttling Liquid Rocket Engine

Angle-Regulating Rule of Guide Vanes of Variable Geometry Turbine Adjusting Mechanism