Abstract:Abstract Flow separation is a major parameter affecting the compressor performance. It reduces the compressor efficiency, limits static pressure rise capability and contributes to instability in compressors. In applied research, there is a lack of understanding of the nature and mechanism of the three-dimensional (3-D) flow separation in the axial compressor especially on the juncture of the endwall and blade corner region. In the present study, the 3-D flow field in an axial compressor cascade has been studied experimentally as well as numerically. For the experimental study part, a linear compressor cascade has been installed in an open loop wind tunnel. The experimental data was acquired for a Reynolds number Rec = 2.98 × 105 based on the blade chord and the inlet flow conditions. The total pressure loss progress through the blade passage has been measured by using calibrated five and seven-hole pressure probes connected to ATX sensor module data acquisition system. The static pressure distribution on the endwall has been measured employing static pressure taps connected to digital micromanometers. To investigate the loss mechanism through the cascade, the total pressure loss coefficient has been calculated from the measured data. The computational fluid dynamics (CFD) study of the flow field was performed to gain a better understanding of the flow features. Two turbulence models, Spalart-Allmaras (S-A) and shear stress transport SST (k-ω) were used. From both parts of study, the flow field development and total pressure loss progress through the cascade have been investigated and compared. Moreover, the received data demonstrated a good agreement between the experimental and computational results. The predicted flow streamlines by numerical calculations showed regions characterized by flow separation and recirculation zones that could be used to enhance the understanding of the loss mechanism in compressor cascades. All measurements taken by 5-hole and 7-hole pressure probes have been analyzed and compared. It was found that their readings were almost the same and there are no excellences for using 7-hole probe. Furthermore S-A turbulence model calculations showed more consistencies with experimental results than SST (k-ω) model.

Numerical Simulation of Secondary Flow in Compressor Cascade

The numerical simulation of vortices structure in compressor cascade with curved blades

The numerical simulation of the secondary flow in compressor cascade with curved blades

Numerical Investigation of Secondary Flows in a Compressor Cascade with Positively Leaned Blades

Numerical Simulation of the Development of the Secondary Flow Vortices and Aerodynamic Characteristics of a Turbine Rotor Cascade

Numerical Study of the Unsteady Flow in a Plane Compressor Cascade

Numerical Simulation of the Influence of Endwall Fence Height on the Secondary Flow in Compressor Cascade

Numerical Study of the Effect of Secondary Vortex on Three-Dimensional Corner Separation in a Compressor Cascade

Numerical Study of the Secondary Flow in Steam Turbine Static Cascade under Varying Conditions

Numerical Simulation on Secondary Flow of Turbine Stator Cascade by CFD

Numerical Simulation of Effect of Blade End Slot on Performance of Compressor Cascade

Influence of Incidence on Secondary Vortex in the Compressor Cascade

Experimental Study and Vortex Analysis in A Linear Compressor Cascade with Active Flow Control

Numerical Analysis of the Weight Distribution of Flow Losses in a Highly Loaded Compressor Cascade with Different Incidences

Experiment and Numerical Simulation of the Performance on Scaled Compressor Cascade and Development of a Prediction Model

Evaluation of Rans Turbulence Models in Simulating the Corner Separation of A High-Speed Compressor Cascade

Numerical Simulation on Secondary Flow of Turbine Stator Cascade with a Large Turn Angle

Experimental and Numerical Investigations of Pressure Loss and 3-D Flow Separations in a Linear Compressor Cascade

Effects of Vortex-Vortex Interaction in A Compressor Cascade with Vortex Generators

Numerical Simulation Investigation on Improvement of Compressor Cascade Performance by SDBD Plasma Aerodynamic Actuation

High-resolution Measurement and Analysis of the Transient Secondary Flow Field in a Turbine Cascade