Abstract:Flow separation control has a wide application prospect in drag reduction for industry. This paper numerically studies the effect of microstructures on flow separation and drag reduction. Simple morphological microstructures, derived from the tilted shark scales, are attached to the wing at an angle of attack. The spacing and height of microstructures are made dimensionless by using the microstructure width and half of the wing width, respectively, that is, d̃m=dm/dAB and h̃m=hm/(H/2). The angle of attack is set to 10°. It is found that microstructures can reduce the motion amplitude of shed vortices, thereby suppressing flow separation and reducing drag. Both the planar and curved microstructures have excellent drag reduction performance. The microstructure spacing d̃m and tilt angle θ should not be too large or too small; otherwise, it will weaken the drag reduction ability. Cases d̃m=1.51, θ=20°, and θ=30° exhibit excellent drag reduction performance. The microstructure has the characteristic for being small, yet it needs to reach a certain height h̃m to effectively reduce drag. The case h̃m=0.667 is the most superior choice. Based on the proposed microstructure shape and spacing, the drag reduction performance of microstructures can reach more than 28%. Meanwhile, the drag reduction performance of microstructures increases with the improvement of the attachment proportion pm, and case pm≥50% is suggested for significant drag reduction performance. Finally, we discuss the drag reduction performance of microstructures on the wing at different angles of attack and find that microstructures can achieve good drag reduction, provided that the pressure drag caused by the flow separation is a significant proportion of the total drag and the flow separation occurs within the controllable range of microstructures.

The Study of Different Fairings for Fairing and Drag Reduction on the Low-wing Layout Aircraft

Study on Cruise Drag Characteristics of Low Drag Normal Layout Civil Aircraft

Research on Wing Plain-form Design Considering Propeller Slipflow

Drag reduction investigation on high-wing aircraft landing gear fairing

The Passive Separation Control of an Airfoil Using Self-adaptive Hairy Flaps

Simulation of Flow Separation at the Wing-Body Junction with Different Fairings

Cowling Design for Wing Root Regions of the Airplane with High Wing Configuration

On the drag reduction of an inclined wing via microstructures with the immersed boundary-lattice Boltzmann flux solver

Research status and prospects for low-altitude and high-speed fairing separation technique

Aerodynamic Design on a Fairing for the Mechanism of Trailing Edge Flap on Large Aircraft

An Investigation of Drag Reduction on Gurney Flaps by an Three-Element Airfoil

Study on Influence of Complex Geometry Details on the Aerodynamic Performance of High-lift System

Aerodynamic Styling of Fairing for Commercial Vehicle Cab

Drag Reduction on the Fuselage Shape

Research on Aerodynamic Performance Impact on Modeling Surfaces of Wing

Fluid Mechanism Analysis on the Interaction Between Natural Laminar Flow Nacelle and Wingbody on a Transonic Aircraft

Boundary-layer Transition of Advanced Fighter Wings at High-Speed Cruise Conditions

Aerodynamic optimization design for civil aircraft considering relaxed static stability

Multi-point aero-structural design optimization of wings considering drag-divergence constraints

Simulation and analysis on separation of low-altitude and high-speed split-type fairing

An innovative study on low surface energy micro-nano coatings with multilevel structures for laminar flow design