Abstract:The loading method of the external excitations generated by the equipment directly affects the predicted result of the mechanical noise which should be the same under different excitation forms for the given equipment. In this paper, general load criteria are proposed to define forces/moments as the standard form and convert other forms of loads in the low-frequency domain. As the most typical form to charac-terize equipment excitation, acceleration load loading methods for different conditions are investigated. The equivalent formula between ideal accelerations and generalized forces establishes the first load cri-terion. The second load criterion is proposed to address the issue of an average acceleration loading, in which the phase and amplitude distribution are both absent, and cannot apply to the load identification. The upper and lower limits of the mechanical noise can be determined by the vibroacoustic transfer func-tion of the three load models, and the energy-averaged value is used to represent the mechanical noise. Furthermore, the third criterion is used to handle the case where the acceleration load is given by the results of a bench test. According to the equipment source descriptor invariance, the conversion method is achieved between the bench test and the real ship based on the transfer function of a load model, and the mechanical noise is predicted by an equivalent energy method. Finally, a three-parameter method to quantitatively evaluate the well-fitting of experimental and numerical results, and the load criteria are well validated by underwater acoustic experiments of an experimental model.(c) 2022 Shanghai Jiaotong University. Published by Elsevier B.V. This is an open access article under the CC BY-NC-ND license ( http://creativecommons.org/licenses/by-nc-nd/4.0/ )

The influence of dynamic loads on the FE model of the ship equipment-base system

FEM analysis of vehicle-bridge vibration considering bridge deck's vibration

Experimental Study on Dynamical Characteristics of Ship Lift System

Analysis of Wind Load Effect on Ship Loader in Shipping Process

Model Analysis of Green Water Phenomena and Loading for Ship Sailing with Slow Speed

Numerical simulation analysis of dynamical performance of equipment protecting from ship-bridge collision

Physical Essence and Influence of Model Parameters on Dynamic Response of Rayleigh Damping

Shock Response Analysis of a Ship Power Shafting System

Vibration Response Analysis of a New Scientific Research Ship Based on Finite Element Modeling

A Two-Step Approach for Evaluating the Dynamic Ultimate Load Capacity of Ship Structures

Analysis of Testing Method for Dynamic Loads of Propulsion Shafting Systems

Experimental Investigation and Numerical Simulation of Ship Stern Structural Vibration Model

Numerical Research on Impacting Load and Structural Response for a Model Experiment of High-speed Craft

Prediction of nonlinear acceleration response of a large container ship and the validation of excessive acceleration failure mode

The load criteria for ship mechanical noise prediction in low frequencies and experimental validation

Dynamic Analysis of Ship-borne Device Based on Sea State Excitation

Numerical modeling and dynamic analysis of a floating bridge subjected to wave, current and moving loads

Dynamic Analysis of the Structure of a Container Ship

Effects of design and fabrication of segmented ship models on test results of wave-induced loads

Dynamic Analysis of Ship Stern with 3D Finite Element Method

Dynamic Ultimate Hull Girder Strength Analysis on a Container Ship under Impact Bending Moments