Abstract:The primary objective of this study is to investigate the potential of using microscopic simulation models and Surrogate Safety Assessment Model (SSAM) for evaluating the safety performance of signalized intersections. A widely used microscopic simulation package VISSIM was used in this study to develop simulation models. The validity of using VISSIM and SSAM for traffic safety analysis at signalized intersections was tested by comparing the simulated conflicts to those measured in the field using traditional traffic conflicts techniques. Of particular interest was to identify if the consistency between simulated and observed conflicts could be improved by calibrating VISSIM simulation models and adjusting threshold values used for defining simulated conflicts in SSAM. A two-stage procedure was proposed in this study to develop, calibrate and validate VISSIM simulation models. It was found that the two-stage calibration procedure greatly improved the goodness-of-fit between simulated conflicts and real-world conflicts. After model calibration, the mean absolute percent error (MAPE) for total conflicts was reduced from 44% to 24%. More specifically, the MAPE value was reduced from 26% to 15% for rear-end conflicts, from 69% to 29% for crossing conflicts, and from 83% to 81% for lane-change conflicts. Linear regression models and the spearman rank correlation coefficient were also developed to study the relationship between simulated conflicts and observed conflicts. Data analysis results showed that there was a reasonable goodness-of-fit between simulated and observed rear-end and crossing conflicts. However, it was also found that the simulated conflicts generated by VISSIM and SSAM are not good indicators for traffic conflicts which are generated by unexpected driving maneuvers such as illegal lane-changes in the real world.

Simulation of Intersection Signal Control of Tram

Q-learning Based Traffic Signal Control Method for an Isolated Intersection

Design and Implementation of Simulation System for Signalized Intersection with Tram Priority

Traffic Signal Control Optimization Strategy Based on Simulation

Vehicle Queue Length at Signal Controlled Intersection

Modeling and simulation of intersection signal control for transit priority

Signal Timing Method of Right——turn Vehicles Based on Mixed Traffic

Development of a Procedure for Using Surrogate Safety Assessment Model and VISSIM for Safety Assessment at Signalized Intersections

Study on Signal Priority Implement Technology of Tram System

Design of an Intelligent Traffic Controller Based on Vehicle Detection Technology

General Multi-Phase Intelligent Control Method for Traffic Flow at Single Intersection

Study on Traffic Control Simulation System Based on VISSIM

Simulation analysis of traffic signal control and transit signal priority strategies under Arterial Coordination Conditions

An Arterial Signal Coordination Optimization Model for Trams Based on Modified AM-BAND

Visual Simulation of Signal Timing in City Intersection

Maximum cycle length optimization method of signalized intersection

A comparison of departure headway at signalized intersection produced by VISSIM and transmodeler

Bus Priority Signal Control for Signalized Intersection without Bus Lane

Integrated Optimization of Tram Schedule and Signal Priority at Intersections to Minimize Person Delay

Research on Variable Lane Signalized Control Method

Simulation study on dynamic response for an intersection