Abstract:Large modulus gear-rack mechanism has strong bearing capacity. They are often used in heavy-duty equipment, i.e. for heavy load lifting. This study is focused on the ultra large modulus heavy duty open gear-rack drive mechanism of the Chinese “Three Gorge Dam” ship lift, of which lubrication design and management plays a critical role in safe operation and service life extension of the mechanism. Against the currently adopted manual oiling which raises concerns from ineffective lubrication, high lubricate wastes as well as risks of maintainers, this study aims to propose lean lubrication design method based on parametric modeling and numerical analysis. A three-dimensional linear contact hybrid elastohydrodynamic lubrication model was established to characterize lubrication behavior under effects of contact area size and morphology. With the EHL model, lean oil supply conditions were exploited based on effective lubricating oil thickness. Given the uncertainty and complexity of lubrication state in actual working conditions, texture design was then proposed for better tribological performance under starved lubrication conditions. The proposed models and methods were applied to the gear-rack drive of the Chinese “Three Gorge Dam” ship lift. The numerical results suggested the proposed lean lubrication plan may consume 4.13% less lubricating oil in one mesh cycle than that calculated by conventional methods. The reduction of lubricating oil consumption can be larger if the high waste from oil oversupply by manual oiling is considered. The output of case study may serve as the basis of further development of lean lubrication system for the gear-rack drive mechanism.

Numerical Simulation of Fluid-Structure Interaction of Marine Water-Lubricated Rubber Bearings

Numerical simulation of flow and heat transfer in journal bearing lubrication

Numerical analysis of the lubricating gap between the gear shaft and the journal bearing in water hydraulic internal gear pumps

Numerical analysis of turbulence effect for coupled journal-thrust water-lubricated bearing with micro grooves

Influence of Cavitation Pressure on Performance of Sliding Bearings

Lubrication and stability analysis of nonlinear rotor-bearing system

Effects of Wear and Shaft-shape Error Defects on the Tribo-dynamic Response of Water-lubricated Bearings Under Propeller Disturbance

A Numerical Investigation of the Effects of Groove Texture on the Dynamics of a Water-Lubricated Bearing–Rotor System

Theoretical and experimental exploration into the fluid structure coupling dynamic behaviors towards water-lubricated bearing with axial asymmetric grooves

Mathematical modeling for nonlinear dynamic mixed friction behaviors of novel coupled bearing lubricated with low-viscosity fluid

Numerical simulations for the fluid-thermal-structural interaction lubrication in a tilting pad thrust bearing

Theoretical and experimental study on influences of surface texture on lubrication performance of a novel bearing

Modelling for Water-Based Liquid Lubrication with Ultra-Low Friction Coefficient in Rough Surface Point Contact

Theoretical and experimental study on the fluid-structure-acoustic coupling dynamics of a new water lubricated bearing

Investigation on the nonlinear dynamic behaviors of water-lubricated bearings considering mixed thermoelastohydrodynamic performances

Numerical Investigation of Turbulence Models for a Superlaminar Journal Bearing

A mixed soft elastohydrodynamic lubrication model of textures in a rotary lip seal

Multi-layered Solid Element for Seismic Analysis of Rubber Bearings Considering Stress Continuity Based on Finite Particle Method

A mixed-lubricated friction model of water lubricated bearing based on fractal theory

Numerical Investigation of Static Characteristic of a Tilting-Pad Journal Bearing Using Shear Stress Transport Model and Air Backflow

The Numerical Solution to Line Contact Elastohydrodynamic Problems under Heavy Load