Preparation and Properties of Chitin Nanofibers/Polylactic Acid Composite

Li Jingjing,Zhao Jingfeng,Sun Jingrong,Li Dagang

DOI: https://doi.org/10.16865/j.cnki.1000-7555.2017.03.029

2017-01-01

Abstract:Chitin nanofibers (CHNFs) reinforced polylactic acid (PLA) composites were prepared by the wet blending method and the polyethylene glycol(PEG) dispersion agent method.The properties of mechanical,thermal and microscopic for CHNFs/PLA composites were investigated.The results demonstrate that the diameter of obtained α-chitin nanofibers is less than 100 nm and the length is about several hundreds of micrometer with threedimensional network structure.An ideal reinforcing effect can be achieved for CHNFs/PLA samples prepared by these two methods.When the content of CHNFs is higher than 30 ％,the mechanical performance of the composite prepared by the wet blending method is better than that of the composite prepared by the PEG method.From the FE-SEM images,it is found that a large number of fibers are distributed on the fracture surface of PLA uniformly and compactly for the samples prepared by the wet blending method.For the samples prepared by the PEG method,some short fiber clusters are entangled with PLA matrix with no obvious phase separation between CHNFs and PLA.This observation reveals that PEG is a good interfacial compatibilizer for CHNFs and PLA.However,the reinforcing effect is weaken due to decrement of the CHNFs aspect ratio for the PEG method,and the wet blending method is an effective pretreatment method for nanofibers.