Receptivity of incompressible convective boundary layers induced by linear thermal forcing

Yang Liu,Sitao Ren

DOI: https://doi.org/10.1063/5.0044638

IF: 4.6

2021-03-01

Physics of Fluids

Abstract:In this study, the convective instability of incompressible convective boundary layers induced by linearly heating condition is investigated by its receptivity to controlled perturbations and the subsequent streamwise evolution of the disturbance waves. The unstable disturbance waves are triggered by two modes of perturbations. The random mode calculations demonstrate the boundary layer could be distinctly divided into a low frequency band (LFB), a mixed frequency band (MFB) and a high frequency band (HFB), which are essentially the same as the extensively studied homogenously heated problems. It is, however, found that the dominant frequency shifts lower in the HFB segment when <i>Ra</i> is higher than 1 × 10⁹ at <i>s</i> = −2, where <i>Ra</i> = <i>gβΔTH</i>³/<i>νκ</i> is Rayleigh number and <i>s</i> = d<i>θ</i>_w(<i>y</i>)/d<i>y</i> is stratification factor. By examining temperature profiles, it is known that this behavior is associated with the negative buoyant effect which fundamentally differentiates the present flow from the classic <i>s</i> = 0 ones. The sinuous mode calculations reveal that the maximum perturbation amplitude is achieved at <i>f</i>_c. From the spectral power of the perturbations in the convective boundary layer, the characteristic frequency <i>f</i>_c is determined and appropriate scale laws are proposed for <i>f</i>_c in various scenarios. In addition, the propagation speed of the instability waves in the boundary layer is obtained from the present calculations. It is revealed that the disturbance wave always travels faster than the base flow and the speed ratio <i>ξ</i> is larger at <i>s</i> = −2 than at <i>s</i> = 0. It is further found that, similar to the perturbation amplitude, the heat transfer also maximizes at <i>f</i>_c.

mechanics,physics, fluids & plasmas